HP E1340A User's Manual
Download Operation & user’s manual of HP E1340A Portable Generator for Free or View it Online on All-Guides.com.
CALibration
The CALibration subsystem has commands that calibrates the HP E1340A.
The subsystem also includes commands to prevent and detect accidental or
unauthorized calibration of the HP E1340A.
Subsystem Syntax CALibration
:AC
:BEGin [no query]
:POINt? <
value> [query only]
:DATA
:AC <
block>
[:DC] <
block>
[:DC]
:BEGin [no query]
:POINt? <
value> [query only]
:STATe
:AC <
state>
:AC:BEGin CALibration:AC:BEGin starts the AC calibration procedure for the HP
E1340A. It sets the HP E1340A up for the first of the measurements in the
procedure. See the “Calibration” section of the HP E1340A Service
Manual for detailed information on the use of this command.
Comments • Most of the HP E1340A’s commands cannot be executed while
calibration is in progress. The
*RST command may be used to
prematurely terminate the calibration procedure without affecting the
stored calibration constants.
• Executable when initiated: No
• Coupled command: No
• Related commands: CALibration:AC:POINt
• *RST Condition: none
CALibration:AC:BEGin
142 HP E1340A Command Reference Chapter 7