Hunter 20715 Owner's Manual

Download Owner's manual and installation manual of Hunter 20715 Fan for Free or View it Online on All-Guides.com.

Brand: Hunter

Category: Fan

Type: Owner's manual and installation manual for Hunter 20715

Pages: 16

Download Hunter 20715 Owner's manual and installation manual

Hunter 20715 Owner's manual and installation manual - Page 1
1
Hunter 20715 Owner's manual and installation manual - Page 2
2
Hunter 20715 Owner's manual and installation manual - Page 3
3
Hunter 20715 Owner's manual and installation manual - Page 4
4
Hunter 20715 Owner's manual and installation manual - Page 5
5
Hunter 20715 Owner's manual and installation manual - Page 6
6
Hunter 20715 Owner's manual and installation manual - Page 7
7
Hunter 20715 Owner's manual and installation manual - Page 8
8
Hunter 20715 Owner's manual and installation manual - Page 9
9
Hunter 20715 Owner's manual and installation manual - Page 10
10
Hunter 20715 Owner's manual and installation manual - Page 11
11
Hunter 20715 Owner's manual and installation manual - Page 12
12
Hunter 20715 Owner's manual and installation manual - Page 13
13
Hunter 20715 Owner's manual and installation manual - Page 14
14
Hunter 20715 Owner's manual and installation manual - Page 15
15
Hunter 20715 Owner's manual and installation manual - Page 16
16
7
45028-01 • 02/15/11 • Hunter Fan Company
2-1. Drill two pilot holes into the wood support structure through the
outermost holes in the outlet box. e pilot holes should be 9/64”
in diameter.
Note: Your fan comes with four pre-installed neoprene noise
isolators.
2-2. read the lead wires from the outlet box down through the hole
in the middle of the hanger bracket.
2-3. Align the slotted holes in the hanger bracket with the pilot holes
you drilled in the wood support structure. For proper alignment
use slotted holes directly across from each other. If you are
installing the fan on an ANGLED ceiling, be sure to orient the
hanger bracket as shown in Illustration 2-3 (left or right view).
Note: e isolators should be ush against the ceiling.
2-4. Place a at washer on each of the two 3” screws and pass the
screws through the slotted holes in the hanger bracket into the
pilot holes you drilled.
Tighten the screws into the 9/64” pilot holes; do not use lubricants
on the screws. Do not over tighten.
Flat Washer
3” Screw
Steps 2-2 – 2-4
Hanger
Bracket
Isolator
Step 2-3 (Angled Ceiling Only)
OR
Ceiling Peak Ceiling Peak
Large
Opening
Large
Opening
LEFT RIGHT
2 Installing the Hanger Bracket