• Home
• Brands
• Hunter Manuals
• Hunter 28343
• Hunter 28343 Installation Instructions

Hunter 28343 Installation Instructions

Download Installation instructions of Hunter 28343 Fan for Free or View it Online on All-Guides.com. This version of Hunter 28343 Manual compatible with such list of devices, as: 28343, 28345, 28405, 28408, 28983

1

2

41490-01 03/12/2009

INSTALLATION INSTRUCTIONS FOR HUNTER

CEILING FAN LIGHT KITS MODELS:

28343, 28344, 28345, 28405, 28406, 28407, 28408, 28982, 28983, 28984, 28985, 28986, 28987

28330, 28331, 28332, 28333, 28334, 28335, 28336, 28337, 28338, 28339, 28340, 28341, 28342

W ARNING

• To avoid possible electrical shock, before in-

stalling light xtur es, disconnect power by

turning off the cir cuit breakers both to the

outlet box and to its associated wall switch

location. If you cannot lock the cir cuit break-

ers in the of f position, secur ely fasten a

prominent war ning device, such as a tag, to

the service panel.

Connect house wiring to the fan befor e at-

taching the light xtur e to the fan.

All wiring must be in accor dance with na-

tional and local electrical codes and ANSI/

NFPA 70. If you ar e unfamiliar with wiring,

you should use a qualied electrician.

CAUTIONS

Read entire text carefully before beginning in-

stallation and save these instructions.

To reduce the risk of electrical shock, install

this light kit only on Hunter ceiling fan

models with removable switch housings.

STEP 1: REMOVING WIRING HARNESS

Before you can install the modular accessory light

kit, you must remove the wiring har ness and its com-

ponents from the modular switch housing on the

fans listed above. You must then install the wiring

harness into the modular accessory light kit.

NOTE: Refer to Figure 1 for the steps listed below.

1. Locate the reversing switch and car efully remove

the two screws holding the reversing switch to

the switch housing. The r eversing switch can now

be removed from the switch housing.

2. Remove the patented br eakaway connector from

the fan pull chain.

3. Carefully loosen the bellmouth nut from the fan

pull chain and remove the fan pull chain switch

from the switch housing.

4. Locate and car efully remove the two capacitors

from the switch housing.

5. You have now disconnected the wiring har ness

and its components fr om the switch housing and

are ready to install them into the modular acces-

sory light kit.

STEP 2: INSTALLING WIRING HARNESS

NOTE: Refer to Figure 1 for steps listed below.

1. Locate the two wir es in the lower switch housing

labeled “Connect Light Here” or “For Light Use”.

One will be white, the other black with a white stripe.

Unscew the wire connectors counterclockwise

to expose the bare metal leads.

2. Locate the white wire and the black wire coming

from the light xture.

Connect the black wir e fr om the light xture to

the black wire with a white stripe from the

lower switch housing.

Connect the white wire from the light xture to

the white wir e from the lower switch housing.

To fasten the wir es, twist the two bare leads to-

gether. Place a wire connector over the intertwined

length of wire and twist clockwise until tight.

Fan Speed

Switch

Capacitor

Reverse Switch

Multi-wire Plug

Connection

Capacitor

Bellmouth Nut

M3 Housing

Assembly Screws

Light Kit Lead Wires

and Wire Connectors

FIGURE 1