• Home
• Brands
• Hunter Manuals
• Hunter 33255
• Hunter 34355 User Manual

Hunter 34355 User Manual

Download Operation & user’s manual of Hunter 33255 Fan, Humidifier for Free or View it Online on All-Guides.com. This version of Hunter 33255 Manual compatible with such list of devices, as: 33255, 33257, 34355, 34356, 34357

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

24

25

26

27

28

29

30

31

32

33

34

35

36

41713-01 07/19/2004 8 ©2004 HUNTER FAN CO.

Cleaning the Humidifi er and the Water Tank

Refi lling the Water Tank

1. When the water tank level is low, turn

the humidifi er ‘OFF’, and unplug.

2. Remove the tank and take it to the sink

or tub to refi ll.

3. Turn the tank upside down and un-

screw the tank cap by turning it counter-

clockwise. Empty the tank, refi ll with fresh

cool water (never use hot water), and replace

the tank cap. Be sure not to overfi ll the tank

as water damage may occur to furniture or

fl ooring due to spillage.

HUNTER WILL NOT ACCEPT RESPONSIBILITY

FOR DAMAGE TO PROPERTY CAUSED BY

WATER SPILLAGE.

4. Carry the tank back to the humidifier.

Turn the tank upright and place it on the

humidifi er. Be sure that the tank is seated

properly in the base. If the tank is properly

located on the base, you will see air bubbles

fl owing up into the tank.

5. Place the full tank on the unit and allow

the water to fi ll the bottom tray. The water is

at the proper level in the bottom tray when

the tank stops bubbling. Run the unit on

“HI” speed for 1

1

⁄2 minutes for optimum

pump operation. Set the unit to the desired

speed.

Many regions have hard water with high con-

centrations of minerals. When water evaporates

from The Care Free

®

Humidifi er Plus Evaporative

Humidifi er, minerals may be left behind. These

minerals can form a hard white scale which can

be removed by following the cleaning instruc-

tions. The frequency of cleaning due to mineral

build up can vary depending upon the quality

of water you may have.

Refer to Figure 1 for part names.

1. Turn the humidifier ‘OFF’ and unplug

the unit.

2. Lift the main housing and remove the

water dispersion tray and the PermaWick™

Filters. The motor is attached to the main

housing. Do not place the motor near

water. Do not use a wet towel on the

motor or motor housing as electrical

shock may occur.

3. The PermaWick™ Filter should be

cleaned in a vinegar and water solution to

remove any mineral buildup. Place in a solu-

tion of one (1) gallon of water and eight (8)

ounces of undiluted white vinegar. Allow the

fi lter to soak for 20 minutes.

4. After soaking, rinse it several times with

clean water. Place the PermaWick™ Filter in

a location where it can drip dry while you

clean the other parts of your humidifi er.

5. Remove the water tank from the base

and empty any water that is left in the tank.

Soak the base in a mixture of one (1) gallon

of water and eight (8) ounces of vinegar for

20 minutes.

6. After soaking, wipe the base with a soft

cloth or sponge to remove any mineral build

up. Rinse with clean water several times. If

you are planning on storing the humidifi er,

be sure the base is completely dry.

7. Fill the water tank with one (1) gal-

lon of water and eight ounces of undiluted

white vinegar. Replace the tank cap and

shake the tank vigorously until all interior

surfaces of the tank have been exposed to

the water/vinegar mixture.

8. Empty the tank of the water/vinegar

mixture. Rinse it several times with clean

water and then replace the tank cap. If you

are planning on storing the humidifi er, dry it

inside and out, leaving the cap off to allow

41713_booklet.indd 8 7/19/04, 7:22:38 PM