Hunter 36517 Owner's Manual

Download Owner's manual of Hunter 36517 Fan, Humidifier for Free or View it Online on All-Guides.com.

Brand: Hunter

Category: Fan , Humidifier

Type: Owner's manual for Hunter 36517

Pages: 12

Download Hunter 36517 Owner's manual

Hunter 36517 Owner's manual - Page 1
1
Hunter 36517 Owner's manual - Page 2
2
Hunter 36517 Owner's manual - Page 3
3
Hunter 36517 Owner's manual - Page 4
4
Hunter 36517 Owner's manual - Page 5
5
Hunter 36517 Owner's manual - Page 6
6
Hunter 36517 Owner's manual - Page 7
7
Hunter 36517 Owner's manual - Page 8
8
Hunter 36517 Owner's manual - Page 9
9
Hunter 36517 Owner's manual - Page 10
10
Hunter 36517 Owner's manual - Page 11
11
Hunter 36517 Owner's manual - Page 12
12
8
44054-01 • 05/18/2011
Maintenance
Wick and Scent Pad Replacement
3
Figure 9.
Scent Pad
UVC Cover
Scent pad replacement:
Your humidier is equipped with a compartment that can hold scented medicine
pads. These typically are scented with mentholatum to help with congestion. The
pads will last approximately 24 hours before needing to be replaced. Use of these
medicine pads is optional and not necessary to operate the unit.
1. Turn the humidier off.
2. The scent pad compartment is located on the back of the humidier directly
under the UVC cover.
3. Slide your nger underneath the edge of the scent pad compartment and
gently pull outward. Figure 9. The scent pad is located inside the compartment.
4. Remove the used scent pad and replace with a new one. Slide the scent pad
compartment back into the unit until it snaps into place.
5. Turn the unit back on and resume operation.
Wick replacement:
The wick in your humidifer is made to last for an entire running season, about 4
months. It is possible, depending on the quality of water in your area, that it may
have to be changed more frequently.
1. Turn the humidier off and unplug it from the wall outlet.
2. Remove the tank for the housing.
3. Locate the 3 lock tabs in the base of the unit. Turn them clockwise until the
base of the tab lines up with the indentions in the base and lift off the housing.
Figure 10.
4. Locate and turn the lock tab clockwise on the base holding the wick frame.
Remove the wick frame and set it aside. Figure 11.
5. Remove the old wick by pulling the bottom of the wick out of the frame rst
and discard.
6. Insert the new wick top rst. Ensure the wick is in between the tabs at the top
of the wick frame then slide the bottom part of the wick into the frame, making
sure not to crush the bottom corners of the wick.
7. Reassemble the unit and rell the water tank if necessary.
8. Turn the unit back on and resume operation.
Figure 10.
Lock Tabs
Figure 11.
Figure 12.