• Home
• Brands
• Husqvarna Manuals
• Husqvarna 142RB
• Husqvarna Brush Cutter User Manual

Husqvarna Brush Cutter User Manual

Download Operation & user’s manual of Husqvarna 142RB Brush Cutter, Trimmer for Free or View it Online on All-Guides.com.

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

24

25

26

27

28

29

30

31

32

16 – English

STARTING AND STOPPING

Check before starting

• Check the blade to ensure that no cracks have formed at

the bottom of the teeth or by the centre hole. The most

common reason why cracks are formed is that sharp

corners have been formed at the bottom of the teeth while

sharpening or that the blade has been used with dull

teeth. Discard a blade if cracks are found.

• Check that the support flange is not cracked due to fatigue

or due to being tightened too much. Discard the support

flange if it is cracked.

• Ensure the locking nut has not lost its captive force. The

nut lock should have a locking force of at least 1.5 Nm.

The tightening torque of the locking nut should be 35-50

Nm.

• Check that the blade guard is not damaged or cracked.

Replace the blade guard if it is exposed to impact or is

cracked.

• Check that the trimmer head and trimmer guard are not

damaged or cracked. Replace the trimmer head or

trimmer guard if they have been exposed to impact or are

cracked.

• Never use the machine without a guard nor with a

defective guard.

• All covers must be correctly fitted and undamaged before

you start the machine.

Starting and stopping

Starting

Cold engine

Ignition: Set the stop switch to the start position.

Air purge: Press the air purge repeatedly until fuel begins to

fill the bulb. The bulb need not be completely filled.

Choke: Set the choke control in the choke position.

!

WARNING! The complete clutch cover and

shaft must be fitted before the machine is

started, otherwise the clutch can come loose

and cause personal injury.

Always move the machine away from the

refuelling area before starting. Place the

machine on a flat surface. Ensure the cutting

attachment cannot come into contact with

any object.

Make sure no unauthorised persons are in

the working area, otherwise there is a risk of

serious personal injury. The safety distance

is 15 metres.

-

-