• Home
• Brands
• Husqvarna Manuals
• Husqvarna 152RB
• Husqvarna 142 RB, 152RB Operator's Manual

Husqvarna 142 RB, 152RB Operator's Manual

Download Operator's manual of Husqvarna 152RB Brush Cutter, Trimmer for Free or View it Online on All-Guides.com.

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

24

25

26

27

28

29

English – 15

Assembling other guards and

cutting equipment

• Fit the guard (A) to the

gear housing using the

support plate (M) and two

screws (L).

• Fit the disc drive (B) on

the output axle.

• Turn the blade axle until

one of the disc drive’s

holes aligns with the

corresponding hole in the

gear housing.

• Insert the locking pin (C)

into the hole to lock the

axle.

• Screw on the trimmer

head (H) in the direction

of rotation.

• Dismantling takes place in

the reverse order.

M

L

A

ASSEMBLY

Assembling the spray guard

(Install the cord cutter and guard extension to the spray

guard.)

1) Fasten the cord cutter

(A) to the spray guard

with two M5 x 25

screws, lock washers

and hex nuts as

shown.

2) Attach the guard

extension (B) to the

guard with the five

M5 x 25 screws,

washers and hex nuts

as shown.

Assembling the flexible shaft

1) Remove the screw and

insert the outer fitting

(with o-ring) into the

joint pipe (A), and

tighten the screw.

2) Insert the outer fitting

into the clutch case with

pulling up the pin (B).

Be sure pin returns to

original position by

spring and outer fitting

never comes off from

clutch case.

Connecting throttle cable and stop

switch wires

1) Insert the throttle cable

through the cable

adjuster sleeve on the

carburettor bracket.

Make sure the end of the

throttle cable housing is

seated positively in the

sleeve.

2) Position the slotted

fitting on the carburettor

so the recessed hole (A) is

away from the cable

adjuster sleeve.

3) Rotate the carburettor

throttle cam and slip the

throttle cable through

the slot in the slotted

fitting, making sure the

cable lug drops into the

recessed hole.

4) Operate the throttle

trigger a few times to

make sure that it works

correctly.

5) Plug the stop switch

wires into the matching

connectors from the

engine. Note that wire

polarity is not important.

6) Bind the throttle cable

and the flexible shaft

with two bands (B).

H