Husqvarna 325HS75 Operator's Manual

Download Operator's manual of Husqvarna 325HS75 Brush Cutter, Trimmer for Free or View it Online on All-Guides.com.

Husqvarna 325HS75 Operator's manual - Page 1
1
Husqvarna 325HS75 Operator's manual - Page 2
2
Husqvarna 325HS75 Operator's manual - Page 3
3
Husqvarna 325HS75 Operator's manual - Page 4
4
Husqvarna 325HS75 Operator's manual - Page 5
5
Husqvarna 325HS75 Operator's manual - Page 6
6
Husqvarna 325HS75 Operator's manual - Page 7
7
Husqvarna 325HS75 Operator's manual - Page 8
8
Husqvarna 325HS75 Operator's manual - Page 9
9
Husqvarna 325HS75 Operator's manual - Page 10
10
Husqvarna 325HS75 Operator's manual - Page 11
11
Husqvarna 325HS75 Operator's manual - Page 12
12
Husqvarna 325HS75 Operator's manual - Page 13
13
Husqvarna 325HS75 Operator's manual - Page 14
14
Husqvarna 325HS75 Operator's manual - Page 15
15
Husqvarna 325HS75 Operator's manual - Page 16
16
Husqvarna 325HS75 Operator's manual - Page 17
17
Husqvarna 325HS75 Operator's manual - Page 18
18
Husqvarna 325HS75 Operator's manual - Page 19
19
Husqvarna 325HS75 Operator's manual - Page 20
20
Husqvarna 325HS75 Operator's manual - Page 21
21
Husqvarna 325HS75 Operator's manual - Page 22
22
MAINTENANCE
Air filter
The air filter (A) should be
cleaned regularly removing
dust and dirt to avoid:
carburetor malfunction
starting problems
reduced engine power
unnecessary wear to
engine parts
abnormal fuel consump-
tion
Clean the filter after every
25 hours or more regularly
if operating conditions are
exceptionally dusty.
Cleaning the air filter
Dismantle the air filter cover (B) and remove the air filter.
Wash in clean, warm soapy water. Ensure that the filter is dry
before refitting.
An air filter used for a long period of time can never be cleaned
completely. Therefore it is necessary to replace the filter from
time to time with a new filter. A damaged air filter must always
be replaced.
If the machine is used in dusty conditions the air filter
should be soaked in oil, see the section on "Oiling the air
filteF.
Oiling the air filter
Always use HUSQVARNA
filter oil, order no. 503 47
73-01. Tile filter oil
contains a solvent to make it
spread evenly through the
filter. You should therefore
avoid skin contact. Put the
filter in a plastic bag and the
pour the filter oil over it.
Knead the plastic bag to
distribute the oil. Squeeze
the excess oil out of the filter
inside the plastic bag and
pour off the excess before
fitting the filter on the
machine. Never use com-
mon engine oil. This would
drain through the filter
quite quickly and collect in
the bottom.
Gearbox
There isa grease nipple (A)
on the gearbox. Use a grease
gun to top up with grease.
This should be carried out
after approximately every 20
working hom_. Use
Husqvarna special grease,
No. 503 98 96-01.
Note that the gearbox must
not be filled completely
with grease. The grease
expands as the machine
heats up during operation.
If the gearbox was
completely filled with grease
it could damage the seals
and lead to leakage.
The lubricant in the gearbox
does not normally need to be
replaced other than with
repair.
Lubrication
Always lubricate the blade
runners with special grease
531 00 60-74 (UL 2001)
before use.
A
English - 1 7