Husqvarna 327P4 Series Operator's Manual
Download Operator's manual of Husqvarna 327P4 Brush Cutter, Lawn and Garden Equipment for Free or View it Online on All-Guides.com.
Brand: Husqvarna
Category: Brush Cutter , Lawn and Garden Equipment , Lawn Mower , Pole Saw , Trimmer
Type: Operator's manual
Model: Husqvarna 327P4 , Husqvarna 327P5x
Pages: 100
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
GENERAL SAFETY PRECAUTIONS
English – 13
1156923-49 Rev. 2 2014-07-02
Lubricating cutting equipment
Chain oil
• Chain oil must demonstrate good adhesion to the
chain and also maintain its flow characteristics
regardless of whether it is warm summer or cold
winter weather.
• As a chain saw manufacturer we have developed an
optimal chain oil which has a vegetable oil base. We
recommend the use of our own oil for both maximum
chain life and to minimise environmental damage.
• If our own chain oil is not available, standard chain oil
is recommended.
• In areas where oil specifically for lubrication of saw
chains is unavailable, ordinary EP 90 transmission oil
may be used.
• Never use waste oil! This is dangerous for yourself,
the machine and the environment.
Filling with chain oil
The oil pump is preset at the factory to satisfy most
lubrication requirements. A full oil tank normally lasts
about the same time as a full fuel tank. Therefore check
the amount of oil in the oil tank when filling the fuel to
prevent damage to the saw chain and bar that may arise
due to a lack of lubrication.
Checking chain lubrication
• Check the chain lubrication each time you refuel. Aim
the tip of the bar at a light coloured surface about 20
cm (8 inches) away. After 1 minute running at 3/4
throttle you should see a distinct line of oil on the light
surface.
Adjusting chain lubrication
When cutting dry or hard species of wood it may be
necessary to increase lubrication. Turn the adjuster screw
anticlockwise to increase the oil flow. Remember that this
will increase oil consumption, check the level in the oil
tank regularly. Turn the adjuster screw clockwise to
decrease the oil flow.
What to do if lubrication does not work:
• Check that the oil channel in the bar is not obstructed.
Clean if necessary.
• Check that the oil channel in the gear housing is
clean. Clean if necessary.
• Check that the bar tip sprocket turns freely. If the chain
lubrication system is still not working after carrying out
the above checks you should contact your service
workshop.
!
WARNING! Poor lubrication of cutting
equipment may cause the chain to snap,
which could lead to serious, even fatal
injuries.