Husqvarna 323E, 325E Operator's Manual

Download Operator's manual of Husqvarna 326E X-series Brush Cutter, Edger for Free or View it Online on All-Guides.com.

Husqvarna 326E X-series Operator's manual - Page 1
1
Husqvarna 326E X-series Operator's manual - Page 2
2
Husqvarna 326E X-series Operator's manual - Page 3
3
Husqvarna 326E X-series Operator's manual - Page 4
4
Husqvarna 326E X-series Operator's manual - Page 5
5
Husqvarna 326E X-series Operator's manual - Page 6
6
Husqvarna 326E X-series Operator's manual - Page 7
7
Husqvarna 326E X-series Operator's manual - Page 8
8
Husqvarna 326E X-series Operator's manual - Page 9
9
Husqvarna 326E X-series Operator's manual - Page 10
10
Husqvarna 326E X-series Operator's manual - Page 11
11
Husqvarna 326E X-series Operator's manual - Page 12
12
Husqvarna 326E X-series Operator's manual - Page 13
13
Husqvarna 326E X-series Operator's manual - Page 14
14
Husqvarna 326E X-series Operator's manual - Page 15
15
Husqvarna 326E X-series Operator's manual - Page 16
16
Husqvarna 326E X-series Operator's manual - Page 17
17
Husqvarna 326E X-series Operator's manual - Page 18
18
Husqvarna 326E X-series Operator's manual - Page 19
19
Husqvarna 326E X-series Operator's manual - Page 20
20
Husqvarna 326E X-series Operator's manual - Page 21
21
Husqvarna 326E X-series Operator's manual - Page 22
22
Husqvarna 326E X-series Operator's manual - Page 23
23
Husqvarna 326E X-series Operator's manual - Page 24
24
English 13
Assembling the blade
Fit the blade as follows:
1. Fit the drive disc (A) on the
outgoing shaft. Make sure
that the edge that fits in
the hole of the blade is
facing outward.
2. Block the blade rotation by
inserting locking pin in the
hole behind the blade
guard engaging it in the
corresponding hole in the
drive disc.
3. Fit the blade (B) on the
drive disc.
4. Fit the support
flange (C). The support
flange must be fitted with
its outer edge hard up
against the blade.
5. Fit the locknut (D). NOTE!
The locknut has left-hand
threads. The tightening
torque of the locknut is 35
50 Nm.
6. Remove the locking pin.
ASSEMBLY
Assembling the loop handlebar
Position the handle on the
shaft. Note that the handle
must be mounted below the
arrow on the shaft.
Fit the bolt, securing plate
and wing nut as shown in the
diagram.
Tighten the wing nut.
A
C
B
D
NOTE! Do not forget to remove the locking pin before using
the machine.
WARNING!
Under no circumstances may the edge cutter
blade be used without the blade guard fitted.
!
Assembling the angle gear
Assemble the angle gear
back on the supporting tube.
Turn the blade so that the
drive shaft engages in the
angle gear.
Position the angle gear so
that its slot is aligned with the
line on the supporting tube.
Firmly tighten the screw.