• Home
• Brands
• Husqvarna Manuals
• Husqvarna 323R, 325RX-Series, 325RDX-Ser
• Husqvarna 323R, 325RX-Series, 325RDX-Series Operator's Manual

Husqvarna 323R, 325RX-Series, 325RDX-Series Operator's Manual

Download Operator's manual of Husqvarna 323R, 325RX-Series, 325RDX-Ser Brush Cutter, Trimmer for Free or View it Online on All-Guides.com. This version of Husqvarna 323R, 325RX-Series, 325RDX-Ser Manual compatible with such list of devices, as: 323R, 325RX-Series, 325RDX-Ser, 325R, 325RD X-SERIES, 325RX, 325RXT-Series

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

24

25

26

27

28

29

30

31

32

33

34

35

36

37

38

39

40

41

42

43

44

English – 19

ASSEMBLY

Assembling the spray guard and

trimmer head Superauto II

• Fit the appropriate

guard (A) for use with

the trimmer head. Hook

the guard onto the shaft

fitting and secure it with

the bolt (L).

• Fit the disc drive (B) on

the output axle.

• Turn the blade axle until

one of the disc drive’s

holes aligns with the

corresponding hole in

the gear housing.

• Insert the locking pin

(C) into the hole to lock

the axle.

• Screw on the trimmer

head (H) in the

direction of rotation.

• Dismantling takes place

in the reverse order.

Assembling other guards and

cutting equipment

rotation (left-hand thread).

• Fit the trimmer head‘s

bottom section (K) on the

cover (I) by pressing the

two sections together with

the cut-outs on the bottom

section aligned with the

catches on the cover.

• To dismantle follow the

instructions in the reverse

order.

• Fit the appropriate guard

(A) for use with the

trimmer head. Hook the

guard onto the shaft fitting

and secure it with the bolt

(L).

• Fit the drive disc (B) on the

output axle.

• Turn the blade axle until

one of the holes in the

drive disc aligns with the

hole in the gear housing.

• Insert the locking pin (C)

in the hole so that the axle

is locked.

• The trimmer head must be

split to be fitted (see the

diagram). Proceed as

follows:

• Insert your finger into the

centre hole of the cover (I)

at the same time as you

hold the cover with your

other fingers. Press the two

catches (J) that extend from

the cut-out on the bottom

section (K) using the

thumb and index finger of

your other hand. Press

apart the trimmer head

using the fingers on the

cover.

• Place the cover (I) and the

support flange (F) on the

output axle.

• Fit the nut (G). The

tightening torque of the

nut is 35-50 Nm (3,5-5

kpm). Use the socket

spanner in the tool kit.

Hold the handle of the

spanner as close to the

trimmer guard as possible.

The nut is tightened when

the spanner is turned

against the direction of

H

K

J

I

G

F

I

A

K

B

C