• Home
• Brands
• ICP Manuals
• ICP C4A436GKD200
• ICP C4A436GKD200 Homeowner's Information

ICP C4A436GKD200 Homeowner's Information

Download Homeowner's information of ICP C4A436GKD200 Air Conditioner for Free or View it Online on All-Guides.com.

1

2

THERMOSTAT

Your air conditioner is controlled by the thermostat mounted

on your wall. The thermostat is a highly sensitive low voltage

device and is available in several different configurations

from different manufacturers. The details listed below are

typical for most installations. Ask your dealer for more spe-

cific information regarding the model of thermostat installed.

Cooling Mode

Set the system selector switch to COOL. The air conditioner

will run until the actual room temperature is lowered to the

point you have selected.

Temperature Control

Set the temperature selector to your desired room temperat-

ure. The air conditioner will run any time the actual room

temperature rises above the point you have selected.

Fan Control

The fan selector switch allows you to run the fan continu-

ously or cycle it automatically with the cooling system. Set

the selector switch to ON for continuous operation or to

AUTO for automatic cycling. For maximum comfort satisfac-

tion, continuous fan operation throughout the year is recom-

mended (selector switch set to ON).

WHAT TO DO IF YOUR SYSTEM DOES

NOT WORK

Before Requesting a Service Call:

1. Check thermostat settings. Make sure to select a tem-

perature below the actual room temperature. Make sure

the system selector switch is in the COOL position.

2. Inspect your return air filter. Replace a dirty filter or clean

a reusable type filter.

3. Check circuit breakers and/or fuses. Reset breakers or

replace fuses as necessary.

4. Inspect the coils and fins on the outdoor unit. Clean away

any obstructions (grass clippings, leaves, dirt, dust, or

lint). Check that branches, twigs, or other debris are not

obstructing the fan blade.

If your system still does not operate, contact

your servicing dealer.

Have the Model and Serial Numbers of the indoor and out-

door units available and be sure to describe the problem.

REGULAR MAINTENANCE

REQUIREMENTS

Your system should be regularly inspected by a qualified

service technician. Between visits, there are some routine

maintenance procedures you can do to help keep your sys-

tem operating at peak performance.

ELECTRICAL SHOCK HAZARD

Failure to turn off electrical power could result in per-

sonal injury or death.

Turn OFF all electrical power to both the indoor and

outdoor units before performing any maintenance or

removing any panels or doors. There may be more

than one electrical disconnect switch.

Air Filter

Inspect air filters at least monthly and replace or clean as re-

quired. Disposable type filters should be replaced. Reusable

type filters may be cleaned by soaking in mild detergent and

rinsing with cold water. Install filters with the arrows on the

side pointing in the direction of air flow.

Dirty air filters are the most common cause of inad-

equate cooling performance, and of compressor

failures.

Condensate Drain

The indoor coil condenses water from the air, and this water

must be disposed through an appropriate drain system. Dur-

ing the cooling season check at least monthly for free flow

of drainage and clean if necessary.

Outdoor Unit Coils

Grass clippings, leaves, dirt, dust, lint from clothes dryers,

and fall-off from trees can be drawn into coils by movement

of the air. Clogged outdoor coils will lower the efficiency of

your unit and could cause damage to the compressor. Clean

debris away from the outdoor coils.

Use a soft bristle brush with light pressure only. Do not dam-

age or bend coil fins. Damaged or bent fins may affect unit

operation.

Painted Surfaces

In geographical areas where the water has a high concen-

tration of minerals (calcium, iron, sulfur, etc.) it is recom-

mended that lawn sprinklers not be allowed to spray on the

unit. Spraying this type of water on the unit may result in pre-

mature deterioration of the paint finish and metal compon-

ents.

Never use a weather cover over the outdoor unit unless it is

a ventilated type or made of breathable fabric that will allow

moisture to evaporate rapidly. A cover that holds moisture

in the unit will cause more rust build-up and damage than

normal exposure to weather.

421 02 5000 01 1