Audiovox AVT-597 Installation Manual

Download Installation manual and owner's manual of Audiovox AVT-597 Car Alarm, Car Video System for Free or View it Online on All-Guides.com.

Brand: Audiovox

Category: Car Alarm , Car Video System , TV

Type: Installation manual and owner's manual

Model: Audiovox AVT-597 , Audiovox EZCPG , Audiovox EZCPT

Pages: 6 (0.29 Mb)

Download Audiovox AVT-597 Installation manual and owner's manual

Audiovox AVT-597 Installation manual and owner's manual - Page 1
1
Audiovox AVT-597 Installation manual and owner's manual - Page 2
2
Audiovox AVT-597 Installation manual and owner's manual - Page 3
3
Audiovox AVT-597 Installation manual and owner's manual - Page 4
4
Audiovox AVT-597 Installation manual and owner's manual - Page 5
5
Audiovox AVT-597 Installation manual and owner's manual - Page 6
6
Removable (Quick-Release) mounting of the E-Z FIT floor console. (Requires
optional Quick-Release Kit: Part Number 0892125)
The E-Z FIT console can be mounted with optional brackets that allow the console to be easily removed from the
vehicle for in-home use or in-hotel use when traveling. This kit contains four (4) U-shaped brackets that
permanently mount to the floor of the vehicle. (Also included in the kit are eight (8) bolts, eight (8) fender washers
and eight (8) locking nuts.) The E-Z FIT console mounts to these brackets and is fastened down with thumbscrews
(See Figure 2 below)
Attach the four (4) U-shaped brackets to the four (4) feet of the E-Z FIT console using the thumbscrews. Make
sure that the brackets are perpendicular to the feet of the console. (See Figure 2 below.)
Figure 2
3
Set the console on the floor of the vehicle and mark where the eight (8) holes of the U-shaped brackets are
to be drilled. (Make sure that you have checked under the vehicle and in the vehicle floor (under the carpet)
for obstructions)
Remove the console from the vehicle.
Using the utility knife, score the carpet over the marks with an ‘X’ so that the drill bit does not ‘grab’ and
unravel the carpet.
Drill eight small 1/8” pilot holes to verify that the holes are in the proper locations.
After verifying that the 1/8” pilot holes are in the proper locations, use the ¼” drill bit to enlarge the pilot
holes.
Set the console on the floor over the holes.
Place the bolts through the brackets (attached to the feet of the console) and into the holes just drilled.
Place one large fender washer over each of the bolts and attach the nuts. (Note: It may be desirable to place
a small circle of silicon sealer around the hole under the vehicle before installing the washer and nut to
prevent moisture from getting into the vehicle.)
Tighten the nuts down securely. Have the second person inside the vehicle hold the bolts securely with the
box-end wrench while the person underneath the vehicle tightens down the nuts. See Figure 3 below.
Plug the cigarette lighter cord into the jack on the console (by driver’s seat). Plug the other end into the
cigarette lighter receptacle.