• Home
• Brands
• Audiovox Manuals
• Audiovox AVT-597
• Audiovox AVT-597 Installation Manual

Audiovox AVT-597 Installation Manual

Download Installation manual and owner's manual of Audiovox AVT-597 Car Alarm, Car Video System for Free or View it Online on All-Guides.com.

1

2

3

4

5

6

Using the Remote Control:

Refer to the section “Remote Control Operation” in your AVT597 owners manual.

128-5238B

Troubleshooting Hints and Tips:

TV or VCP do not turn on:

No picture when playing a tape:

No picture when playing a camcorder:

Remote Control not working:

Make sure that the cigarette lighter cord is plugged into the cigarette lighter

and the base of the console.

Some vehicles do not apply power to the cigarette lighter when the ignition is

turned off. Try turning the ignition switch to the ON or ACC position.

Check to see if there is power at the cigarette lighter plug. The fuse may be

blown in the fuse panel. Replace the fuse and test the system. (IMPORTANT:

Make sure the condition that caused the fuse to blow has been corrected

before replacing the fuse).

The fuses in the TV or VCP may be blown. To check these fuses, the front

bezel of the console needs to be removed. Remove the six screws that hold

the bezel of the console on and remove the bezel. Slide the TV out and check

the fuse on the back. Slide the VCP out and check the fuse on the back.

Replace these fuses if necessary. (IMPORTANT: Make sure the condition that

caused these fuses to blow has been corrected before replacing these fuses).

Replace the front bezel and screws.

Make sure that the TV is turned on.

Check to see that the TV is not in video mode. Press the TV/Video switch to

change between TV and Video modes.

Make sure the brightness control is up.

Make sure that the TV is turned on.

Make sure that the camcorder is properly plugged into the Audio/Video jacks.

Check to see that the TV is in video mode. Press the TV/Video switch to

change between TV and Video modes.

Make sure the brightness control is up.

Check that the Remote is pointed at the TV or VCP.

Check the batteries and replace if they are worn out.