• Home
• Brands
• Jensen Manuals
• Jensen JPA600D - Amplifier
• Jensen JPA1000D Quick Start

Jensen JPA1000D Quick Start

Download Quick start manual of Jensen JPA600D - Amplifier Amplifier for Free or View it Online on All-Guides.com.

1

2

3

1. Disconnect the negative (-) battery terminal.

NOTE: Check your vehicle's owner's manual before disconnecting the battery.

Disconnecting the battery in some vehicles may require an anti-theft code when

reconnecting for stereo operation. Some vehicles may run rough after reconnecting

the battery and require service to have the on-board computer reset. Check with

your local dealer if you are uncertain.

2. Run suitable AWG wire to where the amplifier will be mounted (run 1 foot extra than

you think you will need). Use rubber grommets where wires will pass through the

firewall or other areas of the vehicle. Make certain a fuse holder is placed within 18

inches of the vehicle battery – this is mandatory. Do not place a fuse in the fuse

holder at the battery at this time.

3. Mount the amplifier on a flat surface. Since a flat surface in a modern vehicle is often

difficult to find, an alternative is to cut a piece of 1/2 inch wood slightly larger than

the amplifier mounting area (covered with automotive type carpeting). Mount the

piece of wood, and then mount the amplifier to the carpeted wooden mount.

4. Ground the amplifier using the same AWG wire size used for the power cable. Make

sure the ground location is a clean, unpainted metal surface.

5. Run the RCA and Remote turn-on lead to the amplifier from the head unit.

6. Run speaker wires (16 AWG or larger) from your speakers to the amplifier.

7. Place a suitable size fuse in the fuse holder at the battery.

8. Ensure that the input level control is set to "0.3V".

9. Turn on the head unit and make appropriate amplifier adjustments.

JPA600D/JPA1000D Digital Amp Quick Start Guide

Remote /

Power Antenna

Turn-on Wire

RCA Cable

Need help?

For technical assistance, call

the Jensen customer

support line at 1-800-323-4815.

Fuse Block or Fuse Holder

Minimum Wire Size:

+12V - 8 AWG

Ground - 8 AWG

CHASSIS GROUND

(

+

)

BATTERY

-

( )

GND

+12V

REM

+ +

AMP

CAR STEREO /

SOURCE UNIT

SPEAKERS

( )

( )

(

+

)

(

+

)

L

R

PREAMP / CROSSOVER

MAIN INPUT