Juniper SRX100 Quick Start Manual

Download Quick start manual of Juniper SRX100 Gateway for Free or View it Online on All-Guides.com.

Brand: Juniper

Category: Gateway

Type: Quick start manual for Juniper SRX100

Pages: 6

Download Juniper SRX100 Quick start manual

Juniper SRX100 Quick start manual - Page 1
1
Juniper SRX100 Quick start manual - Page 2
2
Juniper SRX100 Quick start manual - Page 3
3
Juniper SRX100 Quick start manual - Page 4
4
Juniper SRX100 Quick start manual - Page 5
5
Juniper SRX100 Quick start manual - Page 6
6
SRX100 Services Gateway Quick Start
Use the instructions in this quick start to help you connect the SRX100 Services
Gateway to your network. For details, see the SRX100 Services Gateway Hardware
Guide at
http://www.juniper.net/techpubs/en_US/release-independent/junos/information-products/
pathway-pages/srx-series/product/index.html.
SRX100 Services Gateway Front Panel
SRX100 Services Gateway Back Panel
SRX100 Services Gateway Models
The following model of SRX100 Services Gateway is available:
Connecting and Configuring the SRX Series Device
Use the instructions below to connect and set up the SRX100 Services Gateway to
protect your network. Refer to the LEDs on the front of the device to help you determine
the status of the device.
Overview
The SRX100 Services Gateway requires these basic configuration settings to function
properly:
Interfaces must be assigned IP addresses.
Interfaces must be bound to zones.
Policies must be configured between zones to permit or deny traffic.
Source NAT rules must be set.
The device has the following default configuration set when you power it on for the first
time. You can use the device without performing any initial configuration.
Factory-Default Settings:
Factory-Default Settings for Security Policies:
Factory-Default Settings for NAT Rules:
Callout Description Callout Description
1 Power button 4 USB port
2 LEDs: ALARM, POWER,
STATUS, HA
5 Console port
3 RESET CONFIG button 6 Fast Ethernet ports
Callout Description Callout Description
1 Lock slot for security cable 3 Cable tie holder
2 Grounding point 4 Power supply input
g031001
Device DDR Memory NAND Flash Memory
SRX100H2 2 GB 2 GB
Port Label Interface Security Zone DHCP State IP Address
0/0 fe-0/0/0 untrust client unassigned
0/1 to 0/7 fe-0/0/1 to fe-0/0/7 trust server 192.168.1.1/24
Source Zone Destination Zone Policy Action
trust untrust permit
trust trust permit
untrust trust deny
Source Zone Destination Zone Policy Action
trust untrust source NAT to untrust zone
interface