Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Configuration Manual
Download Configuration manual of Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Other for Free or View it Online on All-Guides.com.
Brand: Juniper
Category: Other
Type: Configuration manual for Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN
Pages: 290
Download Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Configuration manual
•
PSD15 Configuration (Route Reflector) on page 163
•
PSD11 Configuration (Router 1) on page 163
•
PSD12 Configuration (Router 2) on page 164
•
PSD13 Configuration (Router 3) on page 165
JCS1200 Configuration
Step-by-Step
Procedure
To configure the parameters required for Routing Engines in the JCS chassis:
1. Log in to the JCS management module CLI.
2. Configure the Routing Engine that is part of PSD15. This Routing Engine is located
in slot 1 of the JCS chassis and acts as the route reflector.
To configure the Routing Engine in slot 1, issue the following command:
system> baydata -b 01 -data “V01–JCS1–SD2–PSD15–REP01–REB00–PRDSCE”
The baydata command specifies the target as a bay blade (-b), identifies the Routing
Engine (blade) in slot 01, and specifies the following parameters:
• V01—Product version, which is 01.
• JCS1—JCS platform identifier, which is 1.
• SD2—RSD identifier, which is 2.
• PSD15—PSD identifier, which is 15.
• REP01—Slot in which the primary Routing Engine resides, which is 01.
• REB00—Slot in which the backup Routing Engine resides. 00 indicates that there
is no backup Routing Engine.
• PRDSCE—Juniper Networks router product. There is a special product type for
the route reflector: Standalone Control Element (SCE).
3. Configure the Routing Engine that is part of PSD11 This Routing Engine is located in
slot 2 of the JCS chassis and acts as standalone router (not a route reflector).
To configure the Routing Engine in slot 2, issue the following command:
system> baydata -b 02 -data “V01–JCS1–SD1–PSD11–REP02–REB00–PRDT640”
The baydata command specifies the target as a bay blade (-b), identifies the blade
(Routing Engine) in slot 02, and specifies the following parameters:
• V01—Product version, which is 01.
• JCS1—JCS platform identifier, which is 1.
• SD1—RSD identifier, which is 1. This router is in SD1, the route reflector is in SD2.
• PSD11—PSD identifier, which is 11.
• REP02—Slot in which the primary Routing Engine resides, which is 02.
159Copyright © 2010, Juniper Networks, Inc.
Chapter 14: Configuration Examples