Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Configuration Manual
Download Configuration manual of Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Other for Free or View it Online on All-Guides.com.
Brand: Juniper
Category: Other
Type: Configuration manual for Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN
Pages: 290
Download Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Configuration manual
•
IP address of one or more DNS name servers on your network
•
Password for the root account
Step Four: Configure Shared Interfaces (Optional)
Optionally, configure shared interfaces. Shared interfaces are configured on both the
Root System Domain (RSD) and the Protected System Domain (PSD).
On the Root System Domain (RSD):
1. Configure the physical interface.
2. For SONET interfaces, configure Frame Relay encapsulation. For Ethernet interfaces,
configure virtual LAN (VLAN) tagging.
3. Configure logical interfaces under the physical interface.
4. For each logical interface:
a. Provide an identifier. For a SONET logical interface, configure a data-link connection
identifier (DLCI). For an Ethernet logical interface, configure a virtual LAN (VLAN)
identifier.
b. Specify the Protected System Domain (PSD) that owns the shared interface.
On the Protected System Domain (PSD):
1. Configure the physical interface (as specified in the RSD configuration).
2. For a SONET interface, configure Frame Relay encapsulation on the physical interface
to match the RSD configuration. For an Ethernet interface, configure VLAN tagging
to match the RSD configuration.
3. For a SONET physical interface, configure the maximum transmission unit (MTU) size
to match the RSD configuration. (If the RSD has no MTU size specified, do not include
an MTU size on the PSD.)
4. Identify the physical interface as a shared interface.
5. Configure the logical interfaces that belong to the PSD (as specified in the RSD
configuration).
6. On each logical interface:
a. Configure the same DLCI (for SONET) or VLAN ID (for Ethernet) that has been
specified in the RSD configuration
b. Specify the logical tunnel interface that is peered with the logical SONET or Ethernet
interface.
The logical unit number of the tunnel interface must be the same as the one that
is configured on the SONET or Ethernet interface.
c. Configure the protocol family and IP address of the logical SONET or Ethernet
interface.
7. Configure the physical tunnel interface.
35Copyright © 2010, Juniper Networks, Inc.
Chapter 5: Configuration Roadmap