Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Configuration Manual
Download Configuration manual of Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Other for Free or View it Online on All-Guides.com.
Brand: Juniper
Category: Other
Type: Configuration manual for Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN
Pages: 290
Download Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Configuration manual
In this example, the IP address of the NTP server is 172.17.28.5, the JCS management
module clock is updated by the NTP server every 60 minutes, and NTP is enabled.
Configuring the Time Zone
To configure the time zone on the JCS management module:
1. Log in to the JCS management module.
2. Use the env command to set JCS management module 1 (mm[1]) as the configuration
target. For example:
system> env —T mm[1]
3. Use the clock command to configure the time zone. For example:
system:mm[1]> clock —g —8 —dst uc
In this example, the clock is configured for 8 hours earlier than UTC (GMT) (-g -8),
and daylight saving time for the USA and Canada (-dst uc) is set.
Configuring the System Name and Contact Information
JCS management module configuration should include the system name of the JCS 1200
platform (to identify the JCS1200 platform on the network), the physical location of the
JCS1200 platform, and a contact person for the JCS1200 platform. Typically, the contact
is someone who has Supervisor access to the JCS1200 platform.
To configure the system name, location, and contact information for the JCS management
module:
1. Log in to the JCS management module.
2. Use the env command to set JCS management module 1 (mm[1]) as the configuration
target. For example:
system> env —T mm[1]
3. Use the config command to configure the system name, location, and contact
information for the JCS. For example:
system:mm[1]> config-name system5-contact“George Chang [email protected]
phone=x2368” —loc “Software Lab, Main Campus, Building 12”
In this example, the system name is system5. This name identifies the JCS on the
network, appears in monitoring command output, and so on. The contact information
is for George Chang and the location is Software Lab.
Configuring SNMP Traps
The Simple Network Management Protocol (SNMP) enables the monitoring of network
devices from a central location. This section describes how to configure SNMP traps on
the JCS management module.
43Copyright © 2010, Juniper Networks, Inc.
Chapter 6: Configuring Basic System Parameters