Kenwood TKR-850 Instruction Manual

Download Instruction manual of Kenwood TKR-850 Marine Radio, Radio for Free or View it Online on All-Guides.com.

Kenwood TKR-850 Instruction manual - Page 1
1
Kenwood TKR-850 Instruction manual - Page 2
2
INSTALLATION
To install the handles onto the front panel of the repeater,
align the handles with the holes on the front panel, then
secure the handles using the supplied screws.
Please consult your dealer for installing the repeater and
antenna.
MICROPHONE
Connect an optional KMC-30 (E type only), KMC-27A,
KMC-27B, or KMC-9C KENWOOD microphone to the
MIC jack on the front panel.
VHF FM REPEATER/ UHF FM REPEATER
TKR-750/ TKR-850
INSTRUCTION MANUAL
KENWOOD CORPORATION
© B62-1327-20 (K,E)
09 08 07 06 05 04 03 02
NOTICES TO THE USER
UNPACKING AND CHECKING EQUIPMENT
Note:
The following unpacking information is for use by your
KENWOOD
dealer, an authorized
KENWOOD
service facility, or the factory.
Carefully unpack the repeater. We recommend that you
identify the items listed in the following table before
discarding the packing material. If any items are missing
or have been damaged during shipment, file a claim with
the carrier immediately.
FCC WARNING
This equipment generates or uses radio frequency energy. Changes or
modifications to this equipment may cause harmful interference unless
the modifications are expressly approved in the instruction manual. The
user could lose the authority to operate this equipment if an unauthorized
change or modification is made.
GOVERNMENT LAW PROHIBITS THE OPERATION OF
UNLICENSED RADIO TRANSMITTERS WITHIN THE
TERRITORIES UNDER GOVERNMENT CONTROL.
ILLEGAL OPERATION IS PUNISHABLE BY FINE OR
IMPRISONMENT OR BOTH.
REFER SERVICE TO QUALIFIED TECHNICIANS ONLY.
metI rebmuNtraP ytitnauQ
erutxiferawdraH4X-2048-12J1
ssalgtnorF4X-5362-01B1
retliF4X-9521-11B1
noihsuC4X-1081-31G4
noihsuC4X-2081-31G4
tooF5X-5740-20J2
tooF4X-2940-20J2
temmorG5X-2030-95J2
eldnaH5X-8140-10K1
swercS54-6003-53N5
drocCD5X-7243-03E1
elbacrotcennoC5X-8223-13E1
esuF5X-7351-50F1
)ylnoepytK(dracytnarraW—1
launamnoitcurtsnIXX-7231-26B1
THANK YOU!
We are grateful you purchased this KENWOOD repeater.
We believe this easy-to-program repeater will be highly
effective in your communications system, and will keep
personnel operating at peak efficiency.
KENWOOD incorporates the latest in advanced technol-
ogy into all of our products. As a result, we feel strongly
that you will be pleased with the quality and features of
this product.
FEATURES
•You can easily program channel data using the KPG-66D
software on a PC.
•You can recall 1 of 16 preset channels using either a PF key
or the external control line.
The firmware can be written to the Flash memory through
an external source.
QT/DQT signalling can be programmed on each channel. It
simultaneously decodes up to 16 different QT/DQT tones.
The interface port can be used with external equipment,
such as a repeater controller.
The repeater has multi-mode capability.
Wide: 30 kHz/ Narrow:15 kHz (TKR-750; K type only)
Wide: 25 kHz/ Narrow:12.5 kHz (TKR-750/ TKR-850)
•You can adjust the following functions from a PC:
Squelch
RX audio signal output (RA)
RX detector signal output (RD)
RX frequency
RF output power
Maximum deviation
TX audio input (TA)
Signalling deviation (TD)
DQT balance
•QT deviation
DQT deviation
•Test tone deviation
CW ID deviation
Repeat gain
TX frequency
PRECAUTIONS
Do not expose the unit to rain or moisture; to prevent fire or
electric shock.
Do not open the unit under any circumstances; to avoid risk
of electric shock.
Do not expose the unit to long periods of direct sunlight, nor
place it close to heating appliances.
Do not place the unit in excessively dusty and/or humid
areas, nor on unstable surfaces.
If you detect an abnormal odor or smoke coming from the
unit, disconnect the power from the unit immediately.
Contact your
KENWOOD service center or dealer.