AUTOTECH 10.430.301K 401K Installation Instructions

Download Installation instructions of AUTOTECH 10.430.301K 401K Other for Free or View it Online on All-Guides.com.

Category: Other

Type: Installation instructions for AUTOTECH 10.430.301K 401K

Pages: 1 (0.13 Mb)

A U T O T E C H

Installation Instructions

Phone 949.240.4000 Fax 949.240.045032240-E Paseo Adelanto, San Juan Capistrano, CA 92675

Part Number: 10.430.301K; 10.430.401K

Description: Lower Stressbar for A2/A3, A4 Chassis

Notes:

The AUTOTECH lower stressbar for the A2, A3, and A4 Chassis VW's is a simple, bolt-on

part that adds structural rigidity in crucial areas by connecting the front a-arm pivot

bolts, thus reducing suspension geometery changes as a result of chassis ex.

Procedure:

1) Raise the front of the car and place on jackstands with handbrake set and wheels chocked

to ensure it is safe to work underneath.

2) Using an 18mm wrench, remove the driver's side front a-arm bolt.

3) Position the lower stressbar (with the center of the bar dropped down in relation to the

ends) and loosely bolt the driver's side into place. VR6 cars with automatic transmissions

may require you to pivot/push the trans forward slightly to gain bolt access.

4) Remove the passenger side front a-arm bolt.

5) Bring the passenger side end of the stressbar up and into position and bolt in place.

6) Tighten front a-arm bolts to specications below. Be sure to use a high strength thread

locking compound (Loctite®) on the bolt when installing.

A2 Chassis: 130Nm (96 ft lb)

A3 Chassis: 50Nm (37 ft lb) plus additional 1/4 turn (90°)

A4 Chassis: 70Nm (52 ft lb) plus additional 1/4 turn (90°)

7) Install the plastic cap(s) on the bar end(s) to nish.

Top Brands