KitchenAid KUWS246EBL00 Installation Instructions

Download Installation instructions of KitchenAid KUWS246EBL01 Beverage Dispenser, Wine Cooler for Free or View it Online on All-Guides.com. This version of KitchenAid KUWS246EBL01 Manual compatible with such list of devices, as: KUWS246EBT02, KUWS246EWH01, KUWS246EBL00, KUWS246EBT00, KUWS246ESS00

KitchenAid KUWS246EBL01 Installation instructions - Page 1
1
KitchenAid KUWS246EBL01 Installation instructions - Page 2
2
KitchenAid KUWS246EBL01 Installation instructions - Page 3
3
KitchenAid KUWS246EBL01 Installation instructions - Page 4
4
Installation Instructions
HOME APPLIANCES
Before installing your Wine Cellar...
Important: Observe all governing codes and ordinances.
Check that you have everything necessary for correct
installation. Proper installation is your responsibility.
Parts supplied for installation
Check that all parts were included.
• grille • literature package
Tools needed for installation
Phillips screwdriver • level
7/32” hex driver and • gloves
rachet wrench
Location for proper performance
This appliance may be installed as a freestanding or
built-in unit. The location must provide the following:
Grounded electrical outlet located within 4 feet of
the lower left rear corner of the wine cellar.
Sturdy floor
to support the weight of the wine
cellar (110 lb.) and contents.
Door clearance
large enough for door to open 90°
minimum. (See “Door swing dimensions.”)
Proper room temperature:
Room temperature
should not fall below 55°F. Do Not install wine
cellar near an oven, radiator, or other heat source.
Protection from weather, water and direct
sunlight.
Open space in front of the grille.
Blocking air flow
in front of the wine cellar could cause wine cellar
to malfunction. Do Not install wine cellar in a
closet or behind a cabinet door.
23-7/8”
width
23” overall
depth without
handle
34” min.
height;
35” with
leveling legs
extended 1”
Built-in installation:
Additional clearance is not needed for air
movement. However, a 1/8” minimum clearance on sides,
top and rear of unit is recommended for ease of removal or
servicing.
Keep cardboard shipping piece or plywood under wine cellar
until it is installed in the operating position to prevent
damage to floor covering.
Top front of
wine cellar
handle
door
90°
23-1/4”
Wine Cellar
Refrigerated Wine Storage System
Important:
Read and save these instructions.
• Installer: Leave Installation Instructions
with the homeowner.
• Homeowner: Keep Installation Instructions for
future reference.
• Save these Installation Instructions for the local
electrical inspector’s use.
Product dimensions
®
top hinge
2" door
thickness
without
handle
Door swing dimensions