Knoll VS105 Installation Instructions

Download Installation instructions of Knoll VS105 Accessory for Free or View it Online on All-Guides.com.

Brand: Knoll

Category: Accessory

Type: Installation instructions for Knoll VS105

Pages: 3

Download Knoll VS105 Installation instructions

Knoll VS105 Installation instructions - Page 1
1
Knoll VS105 Installation instructions - Page 2
2
Knoll VS105 Installation instructions - Page 3
3
Operation: Knoll Systems volume controls are very easy to use. The
VS105 has a total of 12 different volume settings including fully off.
To increase the volume (in this room only), slide the volume control
knob upwards. To lower the volume, slide the volume control knob
downwards.
To set the correct amplifier or receiver volume setting, we
suggest that you turn the VS105 volume control in one room to
maximum. Adjust the amplifier or receiver volume to the loudest
comfortable setting you will use and no further or louder. This way the
VS105 volume control has the most usable settings. If the amp
volume control was set louder, the VS105 volume control would have
to be turned down to be back at a comfortable level allowing less
overall volume positions available.
Warranty
Knoll Systems warrants the VS105 sold in the USA and Canada by authorized
Knoll dealers to be free of defects in materials and workmanship. This warranty
extends for three full years from the date of purchase by the original consumer.
Any products returned to Knoll Systems and found to be defective by Knoll
Systems within the warranty period will be repaired or replaced at Knoll
Systems option, at no charge. Knoll Systems will not be responsible for the
actual cost of installation or removal of the product, nor for any incidental or
consequential damages. Some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation may not apply to
you. This warranty gives you specific legal rights. You may have additional
legal rights that vary from state-to-state.
Specifications
Peak RMS Power Rating
105 watts per channel
Continuous RMS Power
55 watts per channel
Frequency Response
0 to 500,000 Hz
Mounting Depth
1.6" (41mm)
Electrical Junction Box
Fits single gang
Speaker Impedance
4-16 ohms (single or multiple
speakers)
Connection
Detachable screw terminals
Knoll Systems
145 Tyee Drive Point Roberts, WA 98281 USA
14-7163 Vantage Way, Delta BC V4G 1N1 Canada
Tel: (604) 940-1689, fax (855) 734-3363
www.knollsystems.com
VS105
Non-Impedance Matching
Volume Control Installation Instructions v1.0
Warning: To be installed and/or used in accordance with appropriate
electrical codes and regulations.
Caution: Do not install these keypads in an electrical junction box
with 110V or higher unless an approved barrier separates the high and
low voltage sections.
Description: The Knoll Systems VS105 is a twelve-position in-wall
mountable stereo speaker volume control. One or two pairs of
speakers can be safely driven from one stereo amplifier (with 4 ohm
capability) using an equal number of VS105’s.
The VS105 is the smallest size volume control ever made by Knoll, so
it fits almost everywhere. A rotary switch version is available, model
VC105pm.
Smallest size high power
volume control ever
made. Only 1.6” deep.
105 RMS watts per
channel.
Full frequency response 0
Hz to 500,000 +/- 1 dB.
Best sound quality
possible because
autoformers are not used.
Single gang decorator style.
Detachable screw terminals for 12-24 gauge wire.
V-pad design doesn’t burn off excessive heat like
L-pads.