Lanier 480-0081 Material Safety Data Sheet

Download Material safety data sheet of Lanier 480-0081 All in One Printer for Free or View it Online on All-Guides.com.

Brand: Lanier

Category: All in One Printer

Type: Material safety data sheet for Lanier 480-0081

Pages: 3

Download Lanier 480-0081 Material safety data sheet

Lanier 480-0081 Material safety data sheet - Page 1
1
Lanier 480-0081 Material safety data sheet - Page 2
2
Lanier 480-0081 Material safety data sheet - Page 3
3
Lanier Worldwide, Inc.
2300 Parklake Drive, NE
A
tlanta, GA USA 30345-2979
MATERIAL SAFETY DATA SHEET
Emergency Telephone: 800-551-3087
Section 1: Chemical Product and Company Information
Identity:
Black Toner Type 110
MSDS No.
CP- 400
Product ID: 480-0081 Issued: 11/09/2004
Synonyms
& Common
Names:
Uses:
Chemical
Formula:
Black Toner Cassette
Type 110 for Lanier LP036c
Lanier LP036c
Mixture
Supersedes:
Date:
Prepared by:
Approved by:
European
Contact:
06/15/2004
11/09/2004
EH&S Department 770-496-9500
Larry Choskey, Manager, CEH&S
Walter Fricke, Manager, Safety &
Environment,
Lanier Worldwide, Inc.
Im Taubental D-41468 Neuss,
Germany +49-2131-387-177
Section 2: Composition / Information on Ingredients
Component Percent CAS No. Exposure Limits Source
Polyester resin >80 Confidential Not listed N/a
Acrylic resin <10 Confidential Not listed N/a
Carbon black <15 1333-86-4 3.5 mg/m
3
3.5 mg/m
3
OSHA PEL
ACGIH TWA
Silicon compound <10 7631-86-9 Not listed N/a
*PEL as the product: 15mg/m
3
(total dust), 5mg/m
3
(respirable dust)
*TLV as the product: 10mg/m
3
(total dust), 5mg/m
3
(respirable dust)
Section 3: Hazards Identification
HMIS Rating:
FLAMMABILITY = 1 HEALTH = 1
REACTIVITY = 0 SPECIAL = none
Health Hazards (Acute, Chronic, Immediate and Potential): Minimum irritation to respiratory tract may occur as with exposure
to any non-toxic dust. May cause gasping if inhaled. Inhalation should be avoided. May cause temporary eye discomfort.
Health Hazards of Long Term exposure (Chronic): Prolonged inhalation of excessive dust may cause lung damage. It is
attributed to “lung overloading”, a generic response to excessive amounts of any dust retained in the lungs for a prolonged interval.
Use of this product, as intended, does not result in inhalation of excessive dust.
Carcinogenicity: Carbon Black was reclassified as a Group 2B by the IARC in 1996 based upon the result of only the inhalation
study in rats. However, there was not observed the incidence of tumors on the test results on dermal or oral studies. Also, 2-years
inhalation study using a typical toner containing carbon black showed no association between toner exposure and animal tumors.
Section 4: First Aid Measures
Inhalation:
Gargle with water. Remove to fresh air if effects
occur. Get medical attention if needed.
Eye Contact:
In case of contact, immediately flush eyes
with water for 15 minutes. Get medical
attention if needed.
Skin Contact:
Wash with soap and water.
Ingestion:
Dilute stomach contents with several
glasses of water. Get medical attention.
Section 5: Fire Fighting Measures
Suitable extinguishing media: CO
2
, dry chemical, foam or water.
Extinguishing media which may not be used for safety
reasons: none
Special protective equipment for fire fighters: none
UEL: n/a LEL: n/a
Burning rate: 0.223
your document management partner