Lennox 020 Installation
Download Installation of Lennox 020 Furnace for Free or View it Online on All-Guides.com.
Brand: Lennox
Category: Furnace
Type: Installation
Model: Lennox 020 , Lennox OF20 , Lennox OSR20
Pages: 1
1
Technical
OIL KITS AND ACCESSORIES u,e._,o
@1993Lennox Industries Inc.
503,004M
Dallas, Texas 40732H093
9/93
Litho U.S.A.
020 SERIES HEAT EXCHANGER
CLEAN-OUT KIT
INSTALLATION INSTRUCTIONS FOR HEAT EXCHANGER
CLEAN-OUT KIT (54J98) USED ON ALL 020 SERIES UNITS.
1- Clean-out brush
1- Length of vinyl tubing
This kit is may be used to clean the heat exchanger on
any 020, OSR20 or OF20 series oil furnace.
1- Turn off electrical power and oil supply to the
furnace.
2- Remove flue pipe section connecting furnace to
chimney. Clean as necessary with clean-out
brush and vacuum.
3- If the furnace is equipped with a flue box, remove
the flue box cover by removing two screws.
Carefully clean the flue box cover.
4- Adapt the enclosed vinyl tubing so that it may be
connected to a vacuum. It is used as an
attach ment.
5- Use the vacuum to clean around the flue exit of
the heat exchanger.
6- Remove six sheet metal screws securing the
framing of the flue collector box or flue collar to
the heat exchanger. Remove framing or collar.
NOTE - For rear-flue models, remove square
clean-out access panel on unit vestibule panel by
removing six screws. Clean-out plate will now be
exposed. Remove eight nuts and washers that secure
the clean-out plate to the heat exchanger. Carefully
remove clean-out plate and gasket from heat
exchanger. If gasket is damaged it must be replaced.
The heat exchanger passageways are now accessible
for cleaning.
7- Replace the six screw previously removed. This
will seal the heat exchanger to the vest panel and
will not allow soot to fall into the furnace cabinet
during the rest of the clean-out procedure.
8- Continue cleaning the heat exchanger through
the flue exit with the kit supplied brush. Work the
brush through one side of the radiator and then
through the other. Repeat this step so that the
entire radiator surface is covered.
9- Remove clean-out brush and use your vacuum
with vinyl hose attachment to sweep out the
radiator. Work hose through one side of the
radiator, then the other. Repeat the previous two
steps until all soot and debris are removed from
radiator.
10-The crossover section of the heat exchanger
between the inner drum and radiator should be
cleaned next. Open the inspection door on the
unit and position the clean-out brush in a slightly
upward position. The brush end should enter the
crossover section. Clean this area thoroughly.
NOTE - For rear flue models, the heat exchanger
crossover is exposed for easy cleaning when
clean-out plate is removed.
11-Inspect the combustion chamber for soot by
disconnecting oil line then remove burner. DO
NOT USE BRUSH INSIDE COMBUSTION
CHAMBER! Carefully vacuum soot from the
chamber. Once the furnace is put back into
operation, the heat from the flame should burn
the rest of the soot from the combustion chamber.
12- Replace oil burner and connect oil line.
13- Replace flue collector framing or collar and install
flue connector cover using the six screws
previously removed.
NOTE - For rear-flue models, replace gasket,
clean-out cover plate (using the eight nuts and
washers) and clean-out access panel (using the six
screws).
14-Replace flue pipe section connecting furnace to
chimney, seal all joints with approved sealant
materials for the application.
15-Turn on power and oil supply.
16-Refer to unit installation instructions for proper
furnace operation and performance.
Page1