Lexmark M3150 Moving Manual

Download Moving manual of Lexmark M3150 All in One Printer, Printer for Free or View it Online on All-Guides.com.

Lexmark M3150 Moving manual - Page 1
1
Lexmark M3150 Moving manual - Page 2
2
Moving Guide
Before moving the printer
CAUTION—POTENTIAL INJURY: Before moving the printer, follow these guidelines to avoid personal injury or printer
damage:
Turn the printer off using the power switch, and then unplug the power cord from the electrical outlet.
Disconnect all cords and cables from the printer before moving it.
If an optional tray is installed, then remove it from the printer. To remove the optional tray, slide the latch on the right side
of the tray toward the front of the tray until it clicks into place.
Use the handholds located on both sides of the printer to lift it.
Make sure your fingers are not under the printer when you set it down.
Before setting up the printer, make sure there is adequate clearance around it.
Use only the power cord provided with this product or the manufacturer's authorized replacement.
Warning—Potential Damage: Damage to the printer caused by improper moving is not covered by the printer warranty.
Selecting a location for the printer
When selecting a location for the printer, leave enough room to open trays, covers, and doors. If you plan to install any hardware
options, then leave enough room for them also. It is important to:
Set up the printer near a properly grounded and easily accessible electrical outlet.
Make sure airflow in the room meets the latest revision of the ASHRAE 62 standard or the CEN Technical Committee 156
standard.
Provide a flat, sturdy, and stable surface.
Keep the printer:
Clean, dry, and free of dust.
Away from stray staples and paper clips.
Away from the direct airflow of air conditioners, heaters, or ventilators.
Free from direct sunlight and humidity extremes.
Observe the recommended temperatures and avoid fluctuations.
Moving Guide
Page 1 of 2