• Home
• Brands
• Maytag Manuals
• Maytag 110
• Maytag 110 Users Manual & Installation

Maytag 110 Users Manual & Installation

Download User's manual & installation instructions of Maytag 110 Cooktop for Free or View it Online on All-Guides.com.

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

24

25

26

27

28

29

30

31

32

33

34

35

36

29

INSTALLATION

Check the appliance is electrically safe and gas sound when you have fi nished.

Conversion to LP gas

Check in the Technical Data

section at the back of the book

that the cooker is convertible to

the gas you want to use.

This conversion must be performed by a

competent person. After conversion the

installation must comply with the relevant

regulations and also the local electricity supply

company requirements. Read the instructions

before converting this appliance.

Failure to convert the appliance correctly could

invalidate any warranty or liability claims and lead

to prosecution.

This instruction must be used in conjunction with the rest

of the appliance instruction, in particular for information

on Standards, cooker positioning, connection hose

suitability etc.

When servicing or replacing gas-carrying components

disconnect from gas before commencing operation and

check appliance is gas sound after completion.

Do not use re-conditioned or unauthorised gas controls.

Disconnect from the electricity supply before commencing

servicing. Before electrical re-connection, check that the

appliance is electrically safe.

Jets

Remove burner caps and heads. Remove old jets. Fit new

jets (see the table for the correct jets). Reassemble in

reverse order.

Tap Bypas screws

Pull off all the control knobs.

Open the oven doors and remove the 2 fi xing screws, one

at each end, underneath the control panel.

Pull off the push fi t control panel end caps at each end

and remove the end fi xing screws under the end cap.

Lift the control panel, pull forward and disconnect the

wiring from the rear.

A tap bypass screw

Remove the tap bypass screw and replace with the

correct screw. See the table for the correct bypass

screws.

Stick on label

Stick the appropriate label on to the data badge to

indicate the gas the appliance is now set for.

Pressure Testing

Connect the appliance to the gas supply. Check the

appliance is gas sound.

The gas pressure can be measured at one of the hotplate

burner jets (NOT a Wok burner). Make sure that the

cooker is not connected to the electricity supply. Lift off

a burner head. Fit the pressure gauge to the jet. Turn on

one of the other burners and light it with a match. Turn on

the control for the hotplate burner to which the pressure

gauge is fi tted. Press in the knob to allow the gas through

and register the pressure on the gauge.

After checking the pressure, turn the taps off and replace

the burner head.

Reassemble burner top, making sure it is reassembled in

the correct way on the burner body.

Check the appliance is gas sound.

Check operation of all the burners.

Check that the appliance is

electrically safe.

Natural Gas 20mb L.P. Gas

Hotplate

Injector Screw Injector Screw

Wok burner

3.5kW

internal 80

96 3.5kW (246g/h)

internal 54

57

external 129 external 77

Large Burner

3.0kW 134 54 3.0kW (210g/h) 87 40

Medium Burners

1.7kW 109 39 1.7kW (119g/h) 68 32

Small Burner

1.0kW 75 38 1.0kW (70g/h) 51 28