Maytag 4348340 Use And Care Manual
Download Use and care manual of Maytag 4348340 Cooktop for Free or View it Online on All-Guides.com.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
paint section on page 11,
VINYL (Some Oven Handles): Wash with soap and water then dry.
Do not use abrasive or caustic cleaners.
OVEN FINISHES
STANDARD PORCELAIN: Soak stubborn stains with an ammonia
soaked paper towel or set a dish of ammonia water in oven over
night to loosen soil! then scour. Rinse with a mixture of vinegar
and water. When using oven cleaners, follow package directions.
For smooth standard porcelain areas of continuous cleaning
ovens you can use a non-aerosol oven cleaner. Be sure that no
oven cleaner touches tne rougher continuous cleaning finish. You
can remove the oven bottom for cleaning (see pa
e 13). Be sure
that no trace of the oven cleaner sta
i
s in the oven.
a
races of oven
cleaner could put stains on the finis
when heated. To make sure
this does not happen give a final rinse of vinegar and water. CAU-
T!ON: Do not coat thermostat bulb (wire in upper part of oven) with
oven cleaner. Never use oven cleaners on outside range sur-
faces, aluminum, chrome or baked enamel.
CONTINUOUS CLEANING: Follow special instructions for con-
tinuous cleaning ovens on pages 10 and 11. Never use any oven
cfeaners or abrasive cleaners.
OWEN RACKS: Remove from oven (see InstructIons on page 13)
and wash at sink with soap, water and a scouring pad.
BROILER PAN AND GRID: Do not leave in range to cool. If you
clean right away, the soil will steam loose while you are eatrn
Remove pan from broiler and remove fat and drippings.
B
Sprink e
P
an with detergent then cover with a wet cloth or paper towel and
et soak. Later wash in soa and water using a scouring pad as
necessary. Both the pan an 8 the grid are dishwasher safe.
BROILER COMPARTMENT: Wash with soap and water. For heav
%I, use a scouring
s
4
ad or a brush on oven cleaner. Rinse wtl
vinegar and water an dry with a paper towel.
REMOVABLE COOKTOP BURNERS
The cooktop burners on your range may be removed for cleaning.
Be sure all cooktop knobs are turned to OFF and burners are cool,
then remove or raise the cooktop.
II shipping screws were not removed from the burners when the
range was installed, do so now (see your Installation Guide for in-
structions). These screws may be discarded.
12
To remove burners:
1, Gras
P
the burner head and tilt it to the right to release the two
tabs rom the burner support (A in Fig. A).
2. Lift the end of the burner assembly, then ull away lrom the
front of the ran
1
e to free the air shutter rom the gas valve
P
orifice (B in Fig. ).
Check lighter and burner ports (Fig. B). If they are clogged, use a
wire or needle to clear them.
See the Cleaning Instructions on pages 11 and 12. Be careful not
to disturb the air shutter setting while cleaning. If you need lo
readjust the air shutter, see you Installation Guide.
Some models have an “All-Purpose Burner”. Be
sure
that lhe cone-
shaped “All-Purpose Burner” is returned to the right front cooktop
posItIon. Damage to your range may result if smaller burners are us-
ed In tt.ls position
To replace burners:
1. Slip the air shutter over the gas valve orifice (Fig. A).
2. Lower the burner assembly and hook the tab in the slots in the
burner support(Fig. A).
3. Be sure both tabs are in their slots, that the burner sits level and
straight and that the flash tube forms a straight line from the
pilot or igniter to the burner (Fig. B).
Fig. A
Fig. B