MAYTAG 23-11-2233N-006 User's Manual

Download Operation & user’s manual of Maytag 23-11-2233N-006 Dehumidifier for Free or View it Online on All-Guides.com.

Brand: Maytag

Category: Dehumidifier

Type: Operation & user’s manual for Maytag 23-11-2233N-006

Pages: 16

Download Maytag 23-11-2233N-006 Operation & user’s manual

Maytag 23-11-2233N-006 Operation & user’s manual - Page 1
1
Maytag 23-11-2233N-006 Operation & user’s manual - Page 2
2
Maytag 23-11-2233N-006 Operation & user’s manual - Page 3
3
Maytag 23-11-2233N-006 Operation & user’s manual - Page 4
4
Maytag 23-11-2233N-006 Operation & user’s manual - Page 5
5
Maytag 23-11-2233N-006 Operation & user’s manual - Page 6
6
Maytag 23-11-2233N-006 Operation & user’s manual - Page 7
7
Maytag 23-11-2233N-006 Operation & user’s manual - Page 8
8
Maytag 23-11-2233N-006 Operation & user’s manual - Page 9
9
Maytag 23-11-2233N-006 Operation & user’s manual - Page 10
10
Maytag 23-11-2233N-006 Operation & user’s manual - Page 11
11
Maytag 23-11-2233N-006 Operation & user’s manual - Page 12
12
Maytag 23-11-2233N-006 Operation & user’s manual - Page 13
13
Maytag 23-11-2233N-006 Operation & user’s manual - Page 14
14
Maytag 23-11-2233N-006 Operation & user’s manual - Page 15
15
Maytag 23-11-2233N-006 Operation & user’s manual - Page 16
16
Operation oooooooooooooooooooooooooooooooooooooooooooooooooooooooo
Q MAYIrAG
Powei"
Pause
1 hour
Humidily/Temp
oPower,nO,ca,orPress "Power" button to activate unit. Power "On" indicator lights up.
C) Container Full Indicator
An automatic overflow switch and Container "Full" indicator light are provided to turn
the dehumidifier off before the container overflows. When the indicator light on the
control panel glows, the water container must be emptied.
(_ Set Humidity Display
If "Set Humidity" level is lower than the "Room" humidity level: the compressor will
start up and unit will start dehumidification.
If "Set Humidity" level is higher than the "Room" level: the unit will not dehumidify.
After operating several days at the default setting, with doors and windows closed, you
may adjust the "Set Humidity" to a slightly lower percent (drier air) or higher percent
(moist air). If you would like to adjust the "Set Humidity" humidity level, press the '%"
or "-" to adjust the humidistat in S% increments between 30% and 90%.
If "Set Humidity" is set to 35% then unit is in "continuous run" mode. If not
properly monitored this setting could cause excess energy usage.
(_ Room Humidity/Temp Display
The "Room" display will display either the relative humidity or temperature of the
room. The default setting is room humidity. To display the temperature of the room
press the "Humidity/Temp" button. Press it again to go back to the humidity level.
To display the Temperature in Centigrade: hold down the "Humidity/Temp" button
for S seconds.
Humidityfremp
(_ Fan speed Control
Press the "Fan Speed" button if you would like to change the fan speed from "Low" to
"High", Use the high speed to maintain maximum water removal. The lower speed can be used
when quieter operation is desired.
(_ Pause Feature
Press "Pause" button to pause operation of dehumidifier for 1 hour.
In general, dehumidification is not usually needed during conditions of low room temperature.
Optimal relative humidity is between 40 and 50%.
This electronic controlled unit will automatically resume operation after a power failure.
Fan Speed
3