• Home
• Brands
• Maytag Manuals
• Maytag MDB4651AWS - 24 Inch Full Console Dishwasher
• Maytag MDB4651AWS - 24 Inch Full Console Dishwasher Installation Instructions Manual

Maytag MDB4651AWS - 24 Inch Full Console Dishwasher Installation Instructions Manual

Download Installation instructions manual of Maytag MDB4651AWS - 24 Inch Full Console Dishwasher Dishwasher for Free or View it Online on All-Guides.com.

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

24

25

26

27

28

29

30

31

32

33

34

35

36

Tip Over Hazard

Do not use dishwasher until completely installed.

Do not push down on open door.

Doing so can result in serious injury or cuts.

You need to: • Install this dishwasher as specified in these instructions.

• Slowly open dishwasher door while someone grasps the rear • Have everything you need to properly install dishwasher.

of the dishwasher. Remove shipping materials. Close • Contact a qualified installer to ensure that dishwasher is

dishwasher door. Latch the dishwasher door closed, installed to meet all electrical and plumbing national and local

• Observe all governing codes and ordinances, codes and ordinances.

INSTALLATIONREQUIREMENTS

Gather the required tools and parts before starting installation.

Read and follow the instructions provided with any tools listed

here.

Tools Needed

• Pliers • Wood block

• Phillips screwdriver • 8/8"open-end wrench

• Flat-blade screwdriver • Level

• ¾e" and 1¼,,nut drivers or • Cordless drill

hex sockets (new installations only)

• Measuring tape or ruler • 1/2",3/4"and 11/2"hole

• 10" adjustable wrench saw bits

(opens to 11/8"[2.9 cm]) (new installations only)

• Utility knife • Small tubing cutter

(new installations only)

• Flashlight

• Wire stripper

• Shallow pan (new installations only)

• Bath towel

Parts Supplied

Check that all parts are included.

Parts Needed

• 90 ° elbow fitting with 3/8"

N.P.T. external threads on

one end

NOTE: The other end

must fit your water supply

line.

• UL-listed/CSA-approved

twist-on wire connectors

sized to connect

household wiring to

16-gauge wiring

• Plumber's tape or pipe

joint compound

• Copper tubing (3/8"O.D.

suggested) or flexible

braided water supply line

• Direct Wire Connection

Only: UL-listed/CSA-

approved conduit

connector to fit 7/8"

(2.2 cm) hole

(see "Electrical

Requirements")

• Power SupplyCord

Connection: UL-listed

power supply cord kit

(Part Number 4317824)

marked for use with

dishwashers

(see "Electrical

Requirements")

NOTES:

• Parts available for purchase in plumbing supply stores.

• Check local codes.

• Check existing electrical supply. See "Electrical

Requirements."

A. Sound seals (on some models) (2)

B. Countertop mounting screws (2)

C. Mounting screws (8)

B

D. Toekick panel seal

(on some models)

E. Mounting strips (2)

F. Large drain hose clamp

o

IMPORTANT." Observe all governing codes and ordinances.

Failure to meet codes and ordinances could lead to fire or

electrical shock.

Proper installation is your responsibility.

• Grounded electrical supply required

• Contact a qualified installer to ensure that the dishwasher is

installed to meet all electrical and plumbing national and local

codes and ordinances.

• Install the dishwasher as specified in these instructions.

• Have everything you need to properly install dishwasher.

• Keep water lines leading to the dishwasher from freezing to

avoid damage to the dishwasher. Damage from freezing is not

covered by the warranty.

• This dishwasher is manufactured for indoor use only.

• Do not run drain lines, water lines or electrical wiring where

they can interfere with or contact the dishwasher motor or

legs.

• The location where the dishwasher will be installed must

provide clearance between motor and flooring. Motor should

not touch the floor.

• Do not install dishwasher over carpeted flooring.