Maytag 3395316 Installation Instructions Manual
Download Installation instructions manual of Maytag 3395316 Dryer for Free or View it Online on All-Guides.com.
1
2
3
4
5
6
7
8
9
10
11
12
To connect exhaust duct
;rFeugh the right or left
-
1. Remove access panel by releasing
two locking clips with a small, flat-
blade screwdriver. The clips are
located four inches in from each
side
of the access panel.
Personal Injury Hazard
Wear gloves to protect hands from
sharp edges that may be present.
Failure to do so may result In
personal InJury.
2. Remove the duct tape from the
internal exhaust duct and the straight
duct.
3. Remove the screw from the duct
clip that attaches the straight duct to
the back of the cabinet. Depress the
clip to remove the straight duct using
a twisting motion through the rear
exhaust opening.
4. Reach through the rear exhaust
opening and depress center of tabs
on the plastic opening cover on the
side you want to exhaust through.
Remove the cover.
5
plain
end
90” elbow
5. Attach a three- or four-section
elbow to the straight duct using duct
tape.
90”
elbow
.
6. Insert elbow end of duct pieces
through the side opening. Reach
through the access panel opening
and attach elbow to the internal
exhaust duct. Check the length of
straight duct extending out the side
of the cabinet. If duct extends too far
to make the exhaust duct
connection, mark a line around the
straight duct one inch out from the
cabinet. Remove the duct and elbow
and cut the straight pipe to the
length needed. Reinsert the duct
pieces. Use duct tape to connect the
elbow to the internal exhaust duct.
7. Insert the plastic cover into the
rear exhaust opening.
8. Replace the access panels.
9. Use duct tape to seal all Jolnts.
To connect exhaust duct
through the bottom of the
dryer -
Note: You must use a three-section
elbow to connect exhaust duct
through the bottom of the dryer.
1. Check that the legs extend one
inch from the bottom of the dryer.
2. Remove the access panel by
releasing the two locking clips with a
small, flat-blade screwdriver. The clips
are located four inches in from each
side of the access panel. Lift access
panel off the bottom clips and set
aside.
Page 7