• Home
• Brands
• Maytag Manuals
• Maytag Cabrio,- WED5500X
• Maytag W10096988A Installation Instructions Manual

Maytag W10096988A Installation Instructions Manual

Download Installation instructions manual of Maytag Cabrio,- WED5500X Dryer for Free or View it Online on All-Guides.com. This version of Maytag Cabrio,- WED5500X Manual compatible with such list of devices, as: Cabrio,- WED5550X, MEDX500XW, MEDX600XW, WED5550XW, WED5700XW

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

3

INSTALLATION REQUIREMENTS

Tools and Parts

Gather the required tools and parts before starting installation.

Read and follow the instructions provided with any tools listed

here.

Tools needed:

Flat-blade screwdriver #2 Phillips screwdriver

Wire stripper

(direct wire installations)

Tin snips

(new vent installations)

Adjustable wrench that

opens to 1" (25 mm) or

hex-head socket wrench

Vent clamps

1/4" nut driver

(recommended)

Utility knife

Level

Tape measure

Pliers

Caulking gun and

compound (for installing

new exhaust vent)

Parts package is located in dryer drum. Check that all parts

are included.

Parts needed:

Check local codes. Check existing electrical supply and venting,

and read “Electrical Requirements” and “Venting Requirements”

before purchasing parts.

Mobile home installations require metal exhaust system

hardware, available for purchase from the dealer from whom

you purchased your dryer. For further information, please

reference the “Assistance or Service” section of the Dryer

User Instructions.

If using a power supply cord:

Use a UL listed power supply cord kit marked for use with

clothes dryers. The kit should contain:

A UL listed 30-amp power supply cord, rated 120/240 volt ■

minimum. The cord should be type SRD or SRDT and be

at least 4 ft. (1.22 m) long. The wires that connect to the

dryer must end in ring terminals or spade terminals with

upturned ends.

A UL listed strain relief. ■

Location Requirements

You will need:

A location allowing for proper exhaust installation. ■

See “Venting Requirements.”

A separate 30 amp circuit. ■

Parts supplied:

Leveling legs (4)