Maytag MEDC300BW Installation Manual

Download Installation manual of Maytag 29" WIDE Dryer for Free or View it Online on All-Guides.com. This version of Maytag 29" WIDE Manual compatible with such list of devices, as: MEDC300BW, MEDC400BW, MEDX500BW, WED4850BW, WED4800BQ

Maytag 29
1
Maytag 29
2
Maytag 29
3
Maytag 29
4
Maytag 29
5
Maytag 29
6
Maytag 29
7
Maytag 29
8
Maytag 29
9
Maytag 29
10
Maytag 29
11
Maytag 29
12
Maytag 29
13
Maytag 29
14
Maytag 29
15
Maytag 29
16
Maytag 29
17
Maytag 29
18
Maytag 29
19
Maytag 29
20
16
Connect Vent
Connect vent to exhaust outlet
1.
Using a 4" (102 mm) clamp, connect vent to exhaust outlet
in dryer. If connecting to existing vent, make sure vent is
clean. Dryer vent must t over dryer exhaust outlet and inside
exhaust hood. Check that vent is secured to exhaust hood
with a 4" (102 mm) clamp.
Level Dryer
Not Level LEVEL Not Level
NOTE: The dryer must be level for the moisture sensing system
to operate correctly.
Tighten and adjust leveling legs
2.
If dryer is not level or the same height as the washer, prop up
using a wood block. Use wrench to adjust legs up or down,
and check again for levelness. Once legs are level, make sure
all four legs are snug against the oor before tightening them.
Move dryer to nal location
2.
Move dryer to nal location. Avoid crushing or kinking vent.
After dryer is in place, remove corner posts and cardboard
from under the dryer.
Level Dryer
1.
Check levelness of dryer from side to side. Repeat from
front to back.
Complete Installation Checklist
q
Check that all parts are now installed. If there is an extra
part, go back through steps to see what was skipped.
q
Check that you have all of your tools.
q
Dispose of/recycle all packaging materials.
q
Check dryer’s nal location. Be sure vent is not crushed
or kinked.
q
For power supply cord installation, plug into an outlet.
For direct wire installation, turn on power.
q
Check that dryer is level. See “Level Dryer”.
q
Remove lm on console and any tape remaining on dryer.
q
Wipe dryer drum interior thoroughly with a damp cloth to
remove any dust.
q
Read “Dryer Use” in your “Use and Care Guide”.
q
Set the dryer on a full heat cycle (not an air cycle) for
20 minutes and start the dryer.
If the dryer will not start, check the following:
Controls are set in a running or “On” position.
Start button has been pushed rmly.
Dryer is plugged into an outlet and/or electrical supply
is on.
Household fuse is intact and tight, or circuit breaker has
not tripped.
Dryer door is closed.
q
When the dryer has been running for 5 minutes, open the
dryer door and feel for heat. If you feel heat, cancel cycle and
close the door.