Maytag MEDC300BW Installation Manual
Download Installation manual of Maytag 29" WIDE Dryer for Free or View it Online on All-Guides.com. This version of Maytag 29" WIDE Manual compatible with such list of devices, as: 29" WIDE, MEDC300BW, MEDC400BW, MEDX500BW, WED4850BW
Category: Dryer
Type: Installation manual
Model: Maytag 29" WIDE , Maytag MEDC300BW , Maytag MEDC400BW , Maytag MEDX500BW , Maytag WED4800BQ , Maytag WED4850BW , Whirlpool WED4800BQ
Pages: 20
8
Direct Wire
A
B
C
D
E
F
2. Remove terminal block cover
Before you start, disconnect power. Remove hold-down screw
(D) and terminal block cover (A).
A. Terminal block cover
B. External ground conductor screw
C. Center terminal block screw
D. Hold-down screw
E. Neutral ground wire
F. Hole below terminal block cover
Put power supply cord through the strain relief. Be sure that
the wire insulation on the power supply cord is inside the
strain relief. The strain relief should have a tight t with the
dryer cabinet and be in a horizontal position. Do not further
tighten strain relief screws at this point.
For 3-wire Power Supply Cord Connection, see page 9.
For 4 wire Power Supply Cord Connection, continue to
step 3.
Attach power supply cord
to strain relief
2.
A
B
C
D
Attach power supply cord
strain relief
Remove the screws from a 3/4" (19 mm) UL listed strain relief
(UL marking on strain relief). Put the tabs of the two clamp
sections (C) into the hole (B) below the terminal block opening
so that one tab is pointing up (A) and the other is pointing
down (D), and hold in place. Tighten strain relief screws just
enough to hold the two clamp sections (C) together.
1.
Power supply cord strain relief
Power Supply Cord Connection