Maytag 1800 W - 2005 Manual
Download Manual of Maytag 1800 W - 2005 Microwave Oven for Free or View it Online on All-Guides.com.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
Disassembly Procedures
To avoid the risk of electrical shock, personal injury, or death,
disconnect power to oven and discharge the capacitors before
following any disassembly procedure.
WARNING
!
©2006 Maytag Services 16026795 29
Blower Motor
1. Disconnect power to oven and remove outer case,
(see "Outer Case" procedure).
2. Remove outer case.
3. Disconnect wiring from blower motor.
4. Remove screws securing duct assembly to unit.
5. Remove screws securing blower motor assembly to
duct assembly and back panel.
6. Remove screws securing blower motor and slide
blower motor out from the unit.
7. Replace component and reverse procedure to
reassemble.
Splatter Shield
NOTE: Be careful not to bend antenna when removing
splatter shield. Shield snaps into a lip in front of
the oven and three slots in the back.
1. Place your thumbs in the two indentations in front of
the shield.
2. Press lightly towards the back and carefully lower
shield away from antenna.
3. Pull shield out of the back slots and out of the oven.
Splatter
shield
Top Antenna
1. Disconnect power to oven.
2. Remove splatter shield from oven cavity.
3. Remove two mounting rivets on the top of oven cavity
to remove cradle. Support cradle before removing
mounting rivets to avoid damage to antenna
assembly.
4. Replace component and reverse procedure to
reassemble.
Bottom Antenna
1. Disconnect power to oven.
2. Remove oven tray, see "Tray Replacement"
procedure.
3. Remove two mounting rivets on the top of oven cavity
to remove cradle. Support cradle before removing
mounting rivets to avoid damage to antenna
assembly.
4. Replace component and reverse procedure to
reassemble.
Top Stirrer Motor
1. Disconnect power to oven and remove outer case,
(see "Outer Case" procedure).
2. Remove outer case.
3. Disconnect wire terminals from stirrer motor.
4. Remove screws securing stirrer motor to wave guide.
5. Replace component and reverse procedure to
reassemble.
NOTE: When replacing stirrer motor, verify motor shaft is
aligned with antenna shaft before securing with
screws.
Bottom Stirrer Motor
1. Unplug oven and place unit on its back panel.
2. Removing screw securing bottom access panel.
3. Disconnect wire terminals from stirrer motor.
4. Remove screws securing stirrer motor to chassis.
5. Replace component and reverse procedure to
reassemble.