Home | About | Contact

Maytag MMV1164WB5 Installation Instructions Manual

Download Installation instructions manual of Maytag MMV Microwave Oven for Free or View it Online on All-Guides.com. This version of Maytag MMV Manual compatible with such list of devices, as: MMV1164WB3, MMV1164WB4, MMV1164WS5, MMV1164WW4, MMV4206BS0

Maytag MMV Installation instructions manual - Page 1
1
Maytag MMV Installation instructions manual - Page 2
2
Maytag MMV Installation instructions manual - Page 3
3
Maytag MMV Installation instructions manual - Page 4
4
Maytag MMV Installation instructions manual - Page 5
5
Maytag MMV Installation instructions manual - Page 6
6
Maytag MMV Installation instructions manual - Page 7
7
Maytag MMV Installation instructions manual - Page 8
8
Maytag MMV Installation instructions manual - Page 9
9
Maytag MMV Installation instructions manual - Page 10
10
Maytag MMV Installation instructions manual - Page 11
11
Maytag MMV Installation instructions manual - Page 12
12
A, ,_, _ /_t/ d_,_- _ S/_
NOTE: If no wall studs exist within the cabinet opening, do not 1. Using a stud finder, locate the edges of the wall stud(s) within
install the microwave oven. the opening.
See illustrations in "Possible Wall Stud Configurations." 2. Mark the center of each stud, and draw a plumb line down
each stud center. See illustrations in "Possible Wall Stud
Configurations."
Possible Wall Stud Configurations
These depictions show examples of preferred installation configurations with the mounting plate.
No Wall Studs at End Holes
Figure 1
No Wall Studs at End Holes
Figure 2
B
c.................................................................Li _
i
i
I
i
i
i
i
i
i
i
i
C ! !
i !
i i"_ C
D B_I I. D
F
i
i
i
Wall Stud at One End Hole
Figure 3
NOTE: If wall stud is within 6" (15.2 cm) of the vertical
centerline (see "Mark Rear Wall" section), only recirculation or
roof venting installation can be done.
/i i
Wall Studs at Both End Holes
Figure 4
i
i
li
i
i
A. End holes (on mounting plate)
B. Cabinet opening vertical centerline
C. Waft stud centerlines
D. Holes for lag screws
E. Support tabs
F. Mounting plate center markers