Maytag 12828121 Use And Care Manual
Download Use and care manual of Maytag 12828121 Refrigerator for Free or View it Online on All-Guides.com.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
Removing Front-Mounted Handles for
Stainless Steel Freezer Door
1. Remove right side plastic button
plugs at each end of handle
with a very small flat-blade
screwdriver.
• Insert phillips screwdriver
into predrilled hole to remove
screw.
2. Slide handle right and
remove from door clip.
Connecting the Water Supply
To reduce the risk of injury or death, follow
basic precautions, including the following:
• Read all instructions before installing ice maker.
• Do not attempt installation if instructions are not
understood or if they are beyond personal skill
level.
• Observe all local codes and ordinances.
• Do not service ice maker unless specifically
recommended in Use & Care Guide or published
user-repair instructions.
• Disconnect power to refrigerator before installing
ice maker.
•Water damage due to an improper water
connection may cause mold/mildew growth. Clean
up spills or leakage immediately!
WARNING
8
Installation
Removing Front-Mounted Handles for
Stainless Steel Doors
1. Remove plastic button plug at base
of handle with a very small flat-blade
screwdriver.
• Insert phillips screwdriver into
predrilled hole to remove screw.
2. Slide handle down and remove
from door clip.
3. Repeat above steps to remove
other handle.
Installing Front-Mounted Handles for
Stainless Steel Freezer Door
1. Loosen lower door clip on door
with a phillips screwdriver
2. Locate predrilled hole at base of
handle, and fit hollow end of
handle over left door clip.
3. Fit other end of handle over
left door clip and slide left as
far as possible.
NOTE: If end of handle does
not fit over left clip, loosen
right clip further until fit can
be accomplished.
4. Insert phillips screwdriver
into predrilled hole at end of
handle to tighten screw.
Insert plastic button plug into
hole.
cont.