Maytag 27" Troubleshooting Manual
Download Troubleshooting manual of Maytag 27" Washer for Free or View it Online on All-Guides.com.
17
Diagnostic Codes
Diag.
Code
Description Trigger Action to be taken
1 No Drain
The water level fails to drop below the Low
Water level reset within 15 minutes, before
a spin begins.
Displays "nd"
Go to "Will Not Drain"
Troubleshooting Section
2
The door
fails to
unlock
Door failed to unlock after 3attempts
Displays "LO" Go to "Will Not
Unlock" Troubleshooting Section
3 No Fill
Continuous fill of 12 minutes. Total fill of
14minutes.
Displays "nF"
Go to "No Water Fill"
Troubleshooting Section
4
The door
fails to lock
Door failed to lock after 3 attempts
Displays "FL" Go to "Will not lock"
Troubleshooting Section.
5-7 Not Used
8
Water level
sensor fault.
Input signal from water level Sensor
is out of range, Washer will beep and
pause the wash cycle.
Displays "LE"
Go to “No water fill
Troubleshooting”.
9 Not Used
10
Unbalance
detected
during final
spin, which
prevented
the spinner
from
exceeding
400 rpm
Never exceeded 400rpm due to an
unbalance load.
LED – Will display “dc”
Go to "Wet Clothes
"Troubleshooting Section"
E
Water
sensor level
fault.
Water level in the machine is believed to be
above the overflow level. When this
condition is detected, the machine will
automatically begin pumping water out of
the machine until it falls below the overflow
level.
First check to see that water valve
is not stuck. If water valve is OK,
check water level sensor
11
Will not
remember
machine
settings
Difficulty in reading memory
Go to "Clear diagnostic codes"
Disconnect and reconnect the
washer power cord at power
supply outlet.
If condition still exists, replace
machine control board.
12-14 Not Used