STACKED WASHER/GAS DRYER INSTALLATION
REQUIREMENTS
Stacked Washer/Gas Dryer Location
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Do not install in a garage.
Failure to do so can result in death, explosion, or fire.
Selecting the proper location for your washer/dryer improves
performance and minimizes noise and possible washer "walk."
Your washer/dryer can be installed in a basement, laundry room,
or recessed area. See "Drain System."
Companion appliance location requirements should also be
considered.
iMPORTANT: Do not installor store the washer/dryer where
it will be exposed to the weather. Do not store or operate the
washer/dryer in temperatures at or below 32°F (0°C). Some
water can remain in the washer and can cause damage in low
temperatures. Proper installation is your responsibility.
You will need:
[] A water heater set to deliver 120°F (49°C) water to the
washer.
[] A grounded electrical outlet located within 6 ft. (1.8 m) of
where the power cord is attached to the back of the washer.
See "Electrical Requirements."
[] Hot and cold water faucets located within 4 ft. (1.2 m) of the
hot and cold water fill valves, and water pressure of 20-100
psi (137.9-689.6 kPa).
[] A level floor with a maximum slope of 1" (25 mm) under
entire washer/dryer. Installing the washer/dryer on soft floor
surfaces, such as carpets or surfaces with foam backing,
is not recommended.
[] A sturdy and solid floor to support the washer/dryer with
a total weight (water and load) of 450 Ibs (204 kg).
[] A floor drain under the bulkhead. Prefabricated bulkheads
with electrical outlets, water inlet lines, and drain facilities
should be used only where local codes permit.
Stacked washer/gas dryer installation clearances
[] The location must be large enough to allow the washer
and dryer doors to be fully opened.
[] Additional spacing should be considered for ease of
installation and servicing. The doors open more than 180°.
The washer door is not revers ble.
[] Additional clearances might be required for wall, door, and
floor moldings.
[] Additional spacing of 1" (25 mm) on all sides of the washer/
dryer is recommended to reduce noise transfer.
[] Companion appliance spacing should also be considered.
When installing a gas dryer:
IMPORTANT: Observe all governing codes and ordinances.
[] Check code requirements: Some codes limit or do not
permit installation of clothes dryers in garages, closets,
or sleeping quarters. Contact your local building inspector.
[] Make sure that lower edges of the cabinet, plus the back and
bottom sides of the washer, are free of obstructions to permit
adequate clearance of air openings for combustion air. See
"Recessed Area Installation Instructions" below for minimum
spacing requirements.
Recessed Area installation instructions
This washer/dryer may be installed in a recessed area. For
recessed area installations, minimum clearances can be found
on the warning label on the rear of the dryer or in "Dimensions/
Clearances."
The installation spacing is in inches and is the minimum
allowable. Additional spacing should be considered for ease
of installation, servicing, and compliance with local codes and
ordinances.
The dryer must be exhausted outdoors.
8
