McCall 1-1018 Specifications

Download Specifications of McCall 1-1018 Refrigerator for Free or View it Online on All-Guides.com.

Brand: McCall

Category: Refrigerator

Type: Specifications for McCall 1-1018

Pages: 2

Download McCall 1-1018 Specifications

McCall 1-1018 Specifications - Page 1
1
McCall 1-1018 Specifications - Page 2
2
McCall Refrigeration / 81 West Holly Street / Parsons, TN 38363
Phone (731) 847-5570 / Fax (731) 847-9012 / 1-888-REACH-IN (1-888-732-2446) / www.mccallrefrigeration.com
January 2007 / Printed in U.S.A.
B
ASE
M
OUNT
R
EFRIGERATORS
( 27.5" WIDE 1 SECTION )
Cabinet - Cabinets are all metal, inside and out. The top,
back, and bottom are made of galvanized steel. In
addition, all seams are closed and sealed, with metal
edges turned away from the exposed surface. The result
is an integrated structural frame. Internal corners are
coved to conform to NSF standards. Automatic interior
lighting is controlled by a light switch concealed in the
door hinge. The cabinet is supported on four 6 inch
adjustable steel legs.
Doors - Constructed of metal, refrigerator doors are self-
closing and fully insulated. Their cam-lift hinges are
chrome-plated and self-lubricating. Hinges also have a
safety stop that holds the door open, preventing
overswing. Chrome-plated pull handles have built-in
cylinder locks. The full-perimeter, magnetic vinyl gaskets
are removable without the use of tools. Doors easily lift
off, and door perimeters have a built-in, low wattage,
and anti-condensate heater. Door openings are
protected by an impact-resistant, nonconductive PVC
breaker strip with no exposed screws or fasteners.
Insulation - Cabinet body and doors are filled with
pressure-injected polyurethane foam.
Interior Shelves - Three wire shelves are standard.
Shelves have a runner spaced 3/4 inch O.C. with two
reinforcing bars 8 1/2 inch O.C. Coated with 7 mils of
baked-on gray epoxy. The shelves have a saline spray
corrosion resistance of 600 hours. Shelves will support
250 pounds each with maximum cabinet load of 800
lbs. They are supported on stainless steel pilasters, and
are adjustable on 1 inch centers. All three shelves are
interchangeable and can be adjusted without tools or
special parts.
Self-Contained Refrigeration - The condensing unit is
bottom mounted behind a removable hatch cover.
Components include a hermetically sealed compressor,
receiver tank, and thermostatic temperature control.
Thermostatic expansion valve and high-humidity
evaporator coil is located inside the cabinet. Hot gas
condensate evaporator is provided on self contained
systems. The system is balanced to maintain +38°F
average internal air temperature. All components are
factory installed and tested and supplied with an
attached cord and plug, except as noted.
Remote Cabinets - are equipped for permanent
connection. Standard remote units are provided with
capped refrigeration lines, expansion valve, solenoid
valve, electric condensate evaporator, and temperature
control. Condensing unit is not included. All other
features are the same as self-contained units.
Model 1-1018
1000 Series - Stainless steel interior and exterior.
Standard Features
• Bottom-mounted condensing unit
• Expansion valve
• Hot gas condensate evaporator
• Cord and plug attached (115V only, less than 16 amps)
• Interior thermometer
• Self-closing doors with cam-lift hinges
• Chrome-plated door handles with security locks
• R-134a refrigerant
Approval :
AIA #
ITEM #
MODEL #
PROJECT NAME
SIS #
SPECIFICATIONS
1-1018
CLASSIFIED TO
NSF (STD-7-1999)
McCall Refrigeration specification sheets are available
online @ www.mccallrefrigeration.com