• Home
• Brands
• Bakers Pride Manuals
• Bakers Pride BCO-E1
• Bakers Pride BCO-E1 User Manual

Bakers Pride BCO-E1 User Manual

Download Install and operation instructions of Bakers Pride BCO-E1 Convection Oven, Grill for Free or View it Online on All-Guides.com. This version of Bakers Pride BCO-E1 Manual compatible with such list of devices, as: BCO-E1, BCO-E2, Cyclone GDCO-E1 Single, GDCO-E2

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

7

OVEN INTERIOR:

Clean The Racks And Rack Support Guides:

Open the doors and remove all wire racks and rack support guides. Take them to the sink and thoroughly

clean in warm water with mild detergent or soap. Use a nylon scouring pad or stiff nylon brush.

DO NOT USE STEEL WOOL.

Clean The Stainless Steel Interior:

Baked on splatter, oil, grease or discoloration on the stainless steel inside of the oven may be removed with

stainless steel cleaner, or any other similar cleaning agent. NEVER use vinegar or any corrosive cleaner.

Use only cleaners approved for stainless steel. NEVER use cleaning solvents with a hydrocarbon base.

NEVER use a wire brush, steel or abrasive scouring pads, scraper, file or other steel tools.

NOTE: ALWAYS RUB THE STAINLESS STEEL ALONG THE GRAINS.

Clean The Blower Wheel:

To clean the blower wheel, remove and immerse in ammoniated water for 20 to 25 minutes. Then, scrub it

off with a small, stiff brush. The same procedure can be followed for wire racks and rack supports. To

remove the blower wheel, loosen the set screws (2) on the hub of the blower wheel and tighten the 3/8”

wheel puller bolt (supplied) in center of hub (See Fig. 1).

Clean The Porcelain Interior:

Porcelain enamel interiors are designed to be as maintenance free as possible. However, for best results,

the oven should be cleaned regularly. Enameled interiors can be easily cleaned with oven cleaners. KEEP

CLEANING FLUIDS AWAY FROM ELECTRICAL WIRES, LIGHT SOCKETS, SWITCHES AND

CONTROL PANEL.

OVEN EXTERIOR:

Clean The Exterior Stainless Steel:

To remove normal dirt or product residue from stainless steel, use ordinary soap and water (with or without

detergent) applied with a sponge or cloth. Dry thoroughly with a clean cloth. Never use vinegar or corrosive

cleaner. Do not use chorine based cleaners.

To remove grease and food splatter or condensed vapors that have baked on the equipment, apply

cleaners to a damp cloth or sponge and rub cleanser on the metal in the direction of the polished lines on the

metal. Rubbing cleanser as gently as possible in the direction of the polished lines will not mar the finish of

the stainless steel. To remove discoloration, use a non-abrasive cleaner. NEVER use a wire brush, steel or

abrasive scouring pads, scraper, file or other steel tools. NEVER RUB WITH A CIRCULAR MOTION.

!

!

CAUTION: Use mild detergent or soap solution for best results. Abrasive cleaners could scratch

the finish of your unit, marring it’s appearance and making it susceptible to dirt accumulation. DO

NOT use abrasive cleaners or cleaners/sanitizers containing chlorine, iodine, ammonia or bromine

chemicals as these will deteriorate the stainless steel and glass material and shorten the life of the

unit. Use nylon scouring pads. DO NOT use steel wool.

!

!

WARNING: To avoid any injury, turn the power switch off at the fuse disconnect switch/circuit

breaker or unplug the unit from the power source and allow to cool completely before performing

any maintenance or cleaning.

!

WARNING: Unit is not waterproof. To avoid electrical shock or personal injury, DO NOT submerge

in water. DO NOT operate if it has been submerged in water. DO NOT clean the unit with a water jet.

DO NOT steam clean or use excessive water on the unit.

!

Always clean equipment thoroughly before first use. Clean unit daily.

C. CLEANING