Acer HDS WMS100 Reference Manual
Download Reference manual of Acer HDS WMS100 Server for Free or View it Online on All-Guides.com.
208 Chapter 8 Troubleshooting
8.4.5.2 Flash Detected Messages
When the following Flash detected messages are displayed, follow the instructions to resolve
the problem.
Table 8.7 Flash Detected Messages
Message Code Message Text Recovery Measures
RA00xx Microprogram error [FLS]
RA7000 Microprogram revision mismatch
Restarting the equipment.
RB0000 Upload system error Check the microprogram you want to install and install it over
again.
RB0600 No micro program Perform the new installation upgrade.
RB0A00 Upload file SUM check error A sum check error occurred in a read file during an upload.
Check the microprogram you want to install and install it over
again.
RB0E00 Up grade check NG The upgrade check of the microprogram failed. (An upgrade
version of a microprogram does not conform to the
microprogram being upgraded.) Do a new install of the
microprogram.
RB3000 File size error
RB3100 File open error
RB3200 File read error
RB3500 Bad block ID
RB3600 Bad LBA in START 600 DAT
RB7000 Program size too large
Check the microprogram you wish to install.
RB8000 Old microprogram exists If the installation can be continued, the RAID group and LU
deformation are initialized. (In this case, all the data in the disk
drive are deleted. When the data in the disk drive need to be
saved, stop the work and perform the update installation.
RB8300 Empty system retry full install The update installation cannot be executed because a system
does not exist in the disk drive.
Execute a new installation.
RBA000 Down grade check NG The present microprogram version cannot be updated to a
specified microprogram version.
Check the work procedure.
Execute a new installation.
When a Flash detected message other than those shown above is displayed, inform your
Customer Engineer of the message code.