• Home
• Brands
• Multitech Manuals
• Multitech MULTIVOIP MVP-410
• Multitech MVP410 Install Manual

Multitech MVP410 Install Manual

Download Installation instructions of Multitech MULTIVOIP MVP-410 Computer Hardware, Gateway for Free or View it Online on All-Guides.com.

1

2

MVP428 Upgrade Card Installation Instructions_______________________

11. Locate the male 60-pin vertical connector near the LED edge of the main

circuit card. Check that pins are straight and evenly spaced. If not, then

correct for straightness and spacing. Locate the 60-pin female connector

on the upgrade circuit card.

12. Set the upgrade circuit card on top of the main circuit card. Align the

upgrade card’s 4 pairs of phone-jacks with the 4 pairs of holes in the

backplane of the main card. Slide the phone jacks into the holes.

13. Mate the upgrade card’s 60-pin female connector with the main card’s 60-

pin male connector.

*

*

*

*

60-pin connectors

*

These screws (4 places)

attach upgrade card

to main card.

Figure 7. Attaching upgrade card to main circuit card

(secure 4 Phillips screws; mate 60-pin connectors)

14. There are four copper-plated attachment holes, two each at the front and

rear edges of the upgrade card. Attach the upgrade card to the main card

using 4 Phillips screws. The upgrade card should now be firmly attached

to the main card.

15. Slide the main circuit card back into the chassis far enough to allow re-

connection of power cable.

16. Re-connect power cable.

17. Slide the main circuit card fully into the chassis.

18. Re-attach the backplane of the main circuit card to the chassis with 3

screws.

(Doc. #82010151L, Rev B;

Nov 29, 2006)

Installation Instructions

for

MVP428 Upgrade Card

Note: Your MultiVOIP firmware must be at version 6.09 or higher

before you can install the MVP428 Upgrade Card.

In this procedure, you will install an additional circuit board into the MVP410,

converting it from a 4-channel voip to an 8-channel voip.

Procedure in Detail

1. Power down and unplug the MVP410 unit.

2. Using a Phillips driver, remove the blank cover plate at the rear of

the MVP410 chassis. Save the screws.

screws on blank cover plate (2)

Figure 2: Removing screws from blank cover plate

Summary: (A) Attach four standoffs to main circuit card.

(B) Mate the 60-pin connectors (male connector on main

circuit card; female on upgrade card).

(C) Attach upgrade card to main circuit card (4 screws).





*

*

(A)

*

Add standoffs here

(2 places).



Replace main card screws

with standoffs here

(2 places).

(B)

Mate 60-pin

connectors.

(C)

Attach upgrade card

(screws into standoffs

-- 4 places).

Figure 1. Installation Summary