NEC NP4000CM Installation Manual
Download Installation manual of NEC NP3150CM Indoor Furnishing, Projector for Free or View it Online on All-Guides.com.
Brand: NEC
Category: Indoor Furnishing , Projector , Projector Accessories , Racks & Stands , TV Accessories
Type: Installation manual
Model: NEC NP3150CM , NEC NP4000 - WXGA DLP Projector , NEC NP4001 - WXGA DLP Projector
Pages: 2
1
2
5880 Sheridan Boulevard, Arvada, Colorado 80003
Ph: 303-412-0399 ▪ Fax: 303-412-9346
www.displaydevices.com
Ceiling Mount
1. Remove ¼”-20 button head bolt on ceiling plate to remove lower portion of mount.
2. Install the ceiling plate with (4) 5/16” bolts to structural attachment points. Lag screws
may be used when attaching to wood joists.
3. Reattach the lower portion of the mount.
4. Attach interface plate (pn 72-1073) to projector with (5) M4 x 10 pan head Phillips
screws.
5. Align interface plate into holes on mount, slide stand off bolts into slots and tighten. Add
center locking Torx cap screw which attach secures the interface plate to the mount.
6. Attach the wire safety rope to the interface plate with the enclosed coupler.
7. Attach power and signal cables to projector.
8. Adjust left-to-right yaw. When desired position is attained, tighten ¼”-20 ring on
coupler to mount.
9. Loosen tilt adjustment cap screw with enclosed tool and level the projected image to the
screen. Tighten cap screw when a level image is achieved.
10. Loosen up-down pitch adjustment cap screw with enclosed tool and adjust the pitch
angle of the projector. Tighten cap screw when at desired projection position.
11. If desired, add Kensington lock through the opening of the mount head, loop through
cable end and attach to projector.
4X
SEE NOTE
12
4X
3
2
4
5
6
10
9
8
7
4X
11