Netgear FWAG114 Installation Manual
Download Installation manual of NETGEAR FWAG114 - ProSafe Dual Band Wireless VPN Firewall Router Network Router, Wireless Router for Free or View it Online on All-Guides.com.
Brand: NETGEAR
Category: Network Router , Wireless Router
Type: Installation manual for NETGEAR FWAG114 - ProSafe Dual Band Wireless VPN Firewall Router
Pages: 2
Download NETGEAR FWAG114 - ProSafe Dual Band Wireless VPN Firewall Router Installation manual
1
2
c. Connect the Ethernet cable from your broadband modem to the
Internet port (A) on the FWAG114.
d. Connect the Ethernet cable which came with the router from a
Local port on the router (B) to your computer.
e. Turn on the broadband modem and wait about 30 seconds.
f. After the lights on the modem stop blinking, turn on
the FWAG114.
g. Now, turn on your computer.
Installation Guide
Follow these quick steps to install your firewall.
Before you begin, locate the broadband Internet configuration settings from
your Internet Service Provider. You can also consult the Install Assistant on
the ProSafe Dual Band Wireless VPN Firewall CD.
1
1 Connect the Firewall
a. Turn off your computer and broadband modem.
b. Disconnect the Ethernet cable from your computer (A) which
connects to your broadband modem.
h. Verify the following:
• When your turn the firewall on, the power light goes on.
• The test light turns on within a few seconds, and then goes
off after approximately 10 seconds.
• The local lights are lit for any connected computers.
• The Internet light is lit, indicating a link has been
established to the broadband modem.
Note: For wireless placement and range guidelines, and wireless
configuration instructions, please see the Reference Manual on
the ProSafe Dual Band Wireless VPN Firewall CD.
2
2 Log in to the Firewall
Note: To connect to the firewall, your computer needs to be configured
to obtain an IP address automatically via DHCP. For instructions on
how to do this, please see Appendix C in the Reference Manual on the
ProSafe Dual Band Wireless VPN Firewall CD.
a. Connect to the firewall by typing http://192.168.0.1 in the
address field of Internet Explorer or Netscape
®
Navigator.
b. For security reasons, the firewall has its own user name and
password. When prompted, enter
admin for the firewall user
name and password for the firewall password, both in lower
case letters.
Note: The user name and password are not the same as any user
name or password you may use to log in to the Internet.
ProSafe Dual Band Wireless VPN Firewall FWAG114
Broadband modem
A
12VDC, 1.0A
Internet
4321
Reset
Model FWAG114 Wireless
ProSafe VPN Firewall
Broadband modem
12VDC, 1.0A
Internet
4321
Reset
Model FWAG114 Wireless
ProSafe VPN Firewall
Broadband modem
A B
A