Oki PAGE 12i User's Manual
Download Operation & user’s manual of Oki PAGE 12i Adapter for Free or View it Online on All-Guides.com.
3. NETWORK SETUP FOR EACH OPERATING SYSTEM
13
5 Select “Print Server Information” from “Available Options”. Se-
lect the print server you wish to stop, from “Print Server” list.
6 Select “Print Server Status/Control” from “Print Server Informa-
tion” menu.
7 Select “Server Info” from “Print Server Status and Control” menu.
8 Press the Enter key in the “Print Server Info/Status” window. If
you select “Down” , the print server stops right away. If you select
“Going down after current jobs”, the server goes down after the
current print job is completed.
3.2.3.2 Setting Queue Server Mode
This network card can serve as a print server and connect Print Queues.
Set print server, print queue and printer in the File Server in the same
manner as described in Section 3.2.3.1, “Setting Up Remote Printer Mode”.
If the Print Server is not booted up on the file server side, this network
card of AUTO or Queue Server Mode is connected to the file server as a
print server.
Caution:
• To use OKIPAGE 12i printer in Queue Server Mode, you must not set
the password for the print server. If you set the password, you will not
be able to connect this NETWORK card as a print server. To use
OKIPAGE 12i in Remote Printer Mode, you can connect it without
problem even if the password is set for the print server.
• This network card does not support the banner sheet in the Queue
Server Mode. Even if you specify the banner sheet print, it will be ignored.
3.2.3.3 Message display in Remote Printer Mode
This network card temporarily stops receiving next queue(s) while receiv-
ing a job in the NetWare Remote Printer Mode, according to the Specifi-
cation. At this, NetWare server side handles this as temporary discon-
nection and a message to that effect is sent to the Client side. Once the
network card completes receiving of the current job, however, the con-
nection with next queue is made, and receive process starts normally. It
is possible to change the display interval of the message from NetWare
server and user(s) for whom the message is displayed. You may change
the settings as you see fit.