On-Q ev?Q 5000 Instruction / Installation Sheet

Download Instruction/installation sheet of On-Q ev?Q 5000 Speakers for Free or View it Online on All-Guides.com.

Brand: On-Q

Category: Speakers

Type: Instruction/installation sheet for On-Q ev?Q 5000

Pages: 3

Download On-Q ev?Q 5000 Instruction/installation sheet

On-Q ev?Q 5000 Instruction/installation sheet - Page 1
1
On-Q ev?Q 5000 Instruction/installation sheet - Page 2
2
On-Q ev?Q 5000 Instruction/installation sheet - Page 3
3
INSTRUCTION / INSTALLATION SHEET
evōQ™ 5000 Angled In-Ceiling Speaker
IS-0384 Rev. O
301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
©Copyright 2007 by On-Q/Legrand All Rights Reserved. Page 1 of 3
1. Introduction
On-Q/Legrand offers a 6.5”, Angled, In-Ceiling, evōQ™ 5000
series speaker for Home Theater applications. The evōQ™ 5000
Angled In-Ceiling Speaker (P/N HT5655) employs drivers
mounted at a 15° angle (see Figure 1) to the ceiling surface.
This allows the speaker to have identical performance
characteristics as the evōQ™ 5000 In-Ceiling 6.5” Speaker (P/N
364660-01), from any listening position in the room. The speaker
is optimized for the demands of home theater sound. It employs
a 2-way design that features a Poly Cone woofer and a UFLC
(Urethane Film Laminated Cloth) Dome tweeter with swivel
capability. It comes with dual templates with center markings and
paint rings. Optional speaker pre-construction brackets are
available.
NOTE: Although this speaker uses a 6.5” driver, it is
mounted in an 8” speaker frame, which means it requires an
8” speaker pre-construction bracket (P/N 364673-02).
Disclaimer: Make sure you are in compliance with local building codes before installing this speaker.
This On-Q/Legrand evōQ™ 5000 In-Ceiling Speaker is suitable for moisture rich environments such as
bathrooms or saunas, but not outdoor applications.
2. Description
The On-Q/Legrand evōQ™ 5000 speakers are made of a tough semi-flexible plastic frames that feature a
built in foam gasket to minimize vibration and maximize seal-ability. They also feature a perforated metal grill
with an acoustically transparent scrim cloth to enhance the speakers appearance once installed
. All evóQ
speakers, except sub woofers, are paint-able. They also come with painting shields to protect the drivers
while painting. These speakers are suitable for moisture rich environments. They also feature flip out tabs for
easy installation and removal.
3. Installation
Installation of this evōQ™ 5000 speaker is best accomplished at multiple times during new construction, at
“Rough-in” before the drywall is installed, and at “Trim-out” after the drywall is installed and painted.
A. “Rough-in” steps:
NOTE: It is recommended that a minimum of 16 gauge, 4 conductor wire be
used for most applications from the amplifier or volume control to this speaker.
Different gauges can, and should, be used based upon the distance of the
intended run or quality of installation (see Figure 2).
NOTE: All On-Q/Legrand lyriQ™ Audio components accommodate wire gauges
from 18 to 14.
Distance Gauge
<10 Feet 18
10-50 Feet 16
>50 Feet 14
Speaker Wire
Gauge Selection Chart
Figure 2
Figure 1
(shown with grill removed)