On-Q/Legrand ev?Q 3000 Instruction/installation Sheet

Download Instruction/installation sheet of On-Q/Legrand ev?Q 3000 Speakers for Free or View it Online on All-Guides.com.

Brand: On-Q/Legrand

Category: Speakers

Type: Instruction/installation sheet for On-Q/Legrand ev?Q 3000

Pages: 3

Download On-Q/Legrand ev?Q 3000 Instruction/installation sheet

On-Q/Legrand ev?Q 3000 Instruction/installation sheet - Page 1
1
On-Q/Legrand ev?Q 3000 Instruction/installation sheet - Page 2
2
On-Q/Legrand ev?Q 3000 Instruction/installation sheet - Page 3
3
INSTRUCTION / INSTALLATION SHEET
evōQ™ 3000 In-Ceiling and In-Wall
Speakers
IS-0242 Rev. C
301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
©Copyright 2006 by On-Q/Legrand All Rights Reserved. Page 1 of 3
1. Introduction
On-Q/Legrand offers both in-ceiling and in-wall styles of
evōQ™ 3000 speakers. These two styles encompass two
(2) sizes and five (5) part numbers (as shown in Figure 1
to the right). The speakers are optimized for audio
distribution (central sound). All models are 2-way speakers
that feature Mica-Fiber woofers and PEI (Polyetherimide)
Mylar tweeters. These speakers come with dual templates
with center markings and paint rings. Optional speaker
pre-construction brackets are available for all models.
(*P/N 364658-01, 6.5” In-Ceiling Dual Voice Coil Speaker,
is for reference only and NOT part of this instruction
sheet.)
Disclaimer: Make sure you are in compliance with local
building codes before installing these speakers. On-Q
evōQ™ 3000 In-Wall and In-Ceiling Speakers are
suitable for moisture rich environments such as
bathrooms, saunas and outdoor applications.
2. Description
The On-Q/Legrand evōQ™ 3000 speakers are made of a tough semi-flexible plastic frames that feature a
built in foam gasket to minimize vibration and maximize seal-ability. They also feature a perforated metal grill
with an acoustically transparent scrim cloth to enhance the speakers appearance once installed
. All evóQ
speakers, except sub woofers, are paint-able. They also come with painting shields to protect the drivers
while painting. These speakers are suitable for moisture rich environments. They also feature flip out tabs for
easy installation and removal.
3. Installation
Installation of the evōQ™ 3000 speakers is best accomplished at multiple times during new construction, at
“Rough-in” before the drywall is installed, and at “Trim-out” after the drywall is installed and painted.
A. “Rough-in” steps:
NOTE: It is recommended that a minimum of 16 gauge, 2 conductor wire be
used for most applications from the amplifier or volume control to the speaker.
Different gauges can, and should, be used based upon the distance of the
intended run or quality of installation (see Figure 2).
NOTE: All On-Q/Legrand lyriQ™ Audio components accommodate wire gauges
from 18 to 14.
1. Run x/2 conductor (x=gauge preference) stranded speaker wire from the distribution/volume control
to the speaker location (pre-wiring).
Distance Gauge
<10 Feet 18
10-50 Feet 16
>50 Feet 14
Speaker Wire
Gauge Selection Chart
Figure 2
In-Ceiling Style
(
shown w/o
g
rill
)
In-Wall Style
(
shown w/o
g
rill
)
6.5” – P/N 364654-02 (pair)
8” – P/N 364655-02 (pair)
* 6.5” Dual Voice Coil –
P/N 364658-01 (each)
6.5” – P/N 364656-02 (pair)
8” – P/N 364657-02 (pair)
Figure 1