• Home
• Brands
• On-Q/Legrand Manuals
• On-Q/Legrand 364887-01
• On-Q/Legrand 364887-01 Instruction/installation Sheet

On-Q/Legrand 364887-01 Instruction/installation Sheet

Download Instruction/installation sheet of On-Q/Legrand 364887-01 Wireless Access Point for Free or View it Online on All-Guides.com.

1

2

3

301 Fulling Mill Road, Suite G

Middletown, PA 17057

Phone (800) 321-2343 / Fax (717) 702-2546

www.onqlegrand.com

Page 1 of 3

INSTRUCTION/INSTALLATION SHEET

WIRELESS ACCESS POINT 802.11g

IS-0329 REV. A

©Copyright 2005 by On-Q/Legrand All Rights Reserved.

1. Introduction

The On-Q/Legrand Wireless Access Point (WAP) 802.11g, P/N 364887-01 (In-Ceiling) and P/N 364891-01

(In-Wall), are IEEE 802.11g compatible products that provide wireless network access to PCs, PDAs, or

Ethernet Bridges (used for network access by Digital Video Recorders). They are generally placed in the

ceiling or wall of the top floor of the home in a central location to maximize the wireless zone coverage of the

home. They can also be used to create a localized “hot spot”. The supported devices must contain wireless

network interface cards or capabilities in order to allow the freedom of a wireless connection. Because of

most portable devices’ ability to run on battery power, roaming network connections can be maintained

anywhere around or outside the home, within the wireless zone.

2. Description

The On-Q Wireless Access Point 802.11g is designed to be wall (P/N 364891-01) or ceiling (P/N 364887-01)

mounted in a very unobtrusive manner, similar to an in-ceiling speaker or smoke detector (see Figure 1).

Both types mount in a standard plastic three gang switch & outlet box (not included).Each comes with a

Power Over Cat 5e Inserter Module, which is housed in the structured wiring enclosure. The inserter module

provides operating power over the single Cat 5e cable that is run to the WAP. Refer to the supplied User

Guide for WAP performance and coverage information.

3. Installation

The On-Q Wireless Access Point 802.11g is best installed during new construction in two steps; at “rough-in”

after the Electricians are done, but prior to drywall being installed, and at “trim-out” after the drywall is

installed and painted. These steps are detailed below:

“Rough-in” steps:

a. A single Cat 5e should be run in the walls from a plastic three gang switch & outlet box similar to the

Slater® P3-54-RACMH or equivalent at the location in the home where the On-Q Wireless Access Point

(WAP) 802.11g will be installed to the location (On-Q enclosure) where the Inserter Module will be

located (leave extra cable at both ends).

NOTE: The preferred location for the WAP is in the ceiling or wall of the top floor, centrally located in

the home. Since there is a reset tab under the cover of the WAP (see Figure 2) that may need to be

P/N 364887-01

P/N 364891-01

Figure 1