EarthWay 2130 Assembly And Operating Instructions
Download Assembly and operating instructions of EarthWay 2130 Lawn and Garden Equipment for Free or View it Online on All-Guides.com.
Brand: EarthWay
Category: Lawn and Garden Equipment
Type: Assembly and operating instructions for EarthWay 2130
Pages: 4
1
2
3
4
HELPFUL HINTS: READ THE DIRECTIONS BEFORE ASSEMBLY
THIS SPREADER COMES PARTIALLY ASSEMBLED, REQUIRING YOU TO INSTALL THE WHEELS, HANDLE ASSEMBLY AND
CONTROL ROD. IT SHOULD TAKE APPROXIMATELY 10 MINUTES WITH THE USE OF TWO 7/16” WRENCHES AND 1 PAIR
OF PLIERS.
; Clean the impeller plate after each use. Material stuck on the impeller blades will cause uneven spreading.
; Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or faster speeds
will change the spread patterns. Wet material will also change the spread pattern and ow rate.
; Clean your spreader thoroughly after each use. Wash between the shut off plate and bottom of the hopper.
; Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
; When using Rock Salt remove salt from the hopper daily. Rock Salt will reconstitute back into a solid block over night
with humidity. As a preventative measure, spray all metal parts thoroughly (inside the tubing too) with WD-40 to prevent
corrosion.
1. Open carton and remove the handle assembly, wheels, and
spreader from carton.
2. Turn spreader upside-down on to the hopper.
Pt# 53107 PAGE 1
2130 HIGH-OUTPUT Broadcast spreader
ASSEMBLY and OPERATING INSTRUCTIONS Rev. 3-10
EarthWay
EarthWay
EarthWay
EarthWay
®
®
S
L
I
D
E
Gearbox
Axle Assembly
Lower
Handle
Frame
Brace
Cross Brace
Axle Bushing
3. Ensure that the axle bearings are pushed into the axle bushing
on both sides as shown. Install drive wheel (both wheels are
interchangeable) to axle using pin hole nearest to lower handles as
shown. Insert 2” cotter pin through wheel and through axle. Bend
with pliers to prevent pin from falling out.
4. Install coast wheel to axle, then using outside pin hole as shown, insert 1” cotter pin
through axle (not thru the wheel). Bend with pliers to prevent pin from falling out.
2” Cotter Pin
1” Cotter Pin
Coast Wheel
Drive Wheel
PLEASE CALL IF YOU ARE MISSING ANY PARTS, HAVE ANY DIFFICULTY IN ASSEMBLY, OR HAVE ANY QUESTIONS
REGARDING THE SAFE OPERATION OF THIS SPREADER. THIS MODEL INCLUDES LIFETIME TECHNICAL SUPPORT
SUPPORT HOT LINE: 574-848-7491 or 800-294-0671, email: techsupport@earthway.com SKYPE: EARTHWAY.TECH